Sony Xperia XZS

Sony Xperia XZS: Technical Characteristics

Dimensions: 146 x 72 x 8.1 mm

Weight: 161 g

Display: 5.2 inches, IPS LCD, 1080 x 1920 pixels

Processor: Qualcomm MSM8996 Snapdragon 820

RAM: 4 GB

Internal Storage: 32/64 GB, expandable via microSD up to 256 GB

Battery: Non-removable Li-Ion 2900 mAh battery

Operating System: Android 7.1 (Nougat), upgradable to Android 8.0 (Oreo)

Rear Camera: 19 MP, f/2.0, predictive phase detection and laser autofocus

Front Camera: 13 MP, f/2.0

Connectivity: Wi-Fi 802.11 a/b/g/n/ac, Bluetooth 4.2, NFC, USB Type-C

Instructions to Replace Sony Xperia XZS

Tools Needed

• Phillips screwdriver
• Plastic pry tools
• Suction cup
• Tweezers
• Adhesive strips
• Heat gun or hairdryer

Step-by-Step Replacement Guide

Step 1: Prepare Your Workspace

Ensure you have a clean, flat workspace with good lighting. Organize all necessary tools and components.

Step 2: Power Off the Device

Turn off your Sony Xperia XZS and remove the SIM card and microSD card, if installed.

Step 3: Open the Back Cover

Use a heat gun or hairdryer to soften the adhesive around the back cover of the phone. Gently heat the edges for about 1-2 minutes.

Using a suction cup, lift the back cover slightly to create a small gap. Insert a plastic pry tool into the gap and carefully work your way around the edges to release the adhesive. Be gentle to avoid damaging the back cover or internal components.

Step 4: Remove the Battery

Once the back cover is removed, locate the battery connector. Use a plastic pry tool or tweezers to disconnect the battery cable. Next, gently lift the battery from its compartment. It may be held down with adhesive, so be patient and careful.

Step 5: Remove Protective Covers and Other Components

• Locate and unscrew any Phillips screws securing the protective covers over the motherboard and other components.
• Carefully remove the protective covers using plastic pry tools or tweezers.
• Note the positions and types of screws for reassembly.

Step 6: Disconnect Cables and Remove the Motherboard

• Disconnect all ribbon cables and connectors from the motherboard using tweezers or a plastic pry tool.
• Remove any additional screws holding the motherboard in place.
• Carefully lift the motherboard out of the device.

Step 7: Replace the Necessary Components

At this stage, you can replace any faulty components such as the screen, charging port, cameras, etc. Follow similar disconnection steps for each component to avoid damage.

Step 8: Reassemble the Device

• Carefully place the motherboard back into its original position and reconnect all ribbon cables and connectors securely.
• Reinstall any screws and protective covers that were removed, ensuring they are placed in their original positions.
• Reconnect the battery cable and ensure it is securely connected.

Step 9: Close the Back Cover

Before closing the back cover, ensure all components are correctly installed and secured. Apply new adhesive strips around the edges of the back cover. Carefully align and press the back cover into place, applying gentle pressure to secure the adhesive.

Step 10: Power On and Test

Insert the SIM card and microSD card, if applicable. Power on your Sony Xperia XZS and test all functions to ensure the replacement was successful and the device operates correctly.

Congratulations! You have successfully replaced components on your Sony Xperia XZS.