TCL 20 Pro 5G spare parts

    There are 15 products.

    TCL 20 Pro 5G Repuestos Technical Characteristics

    The TCL 20 Pro 5G smartphone is a device that stands out with wonderful features and advanced technology. Here are some key components, or "repuestos," of the phone:

    • Display: 6.67 inches, AMOLED
    • Resolution: 1080 x 2400 pixels
    • Battery: 4500 mAh, Non-removable Li-Po
    • RAM and Storage: 256G...

    TCL 20 Pro 5G Repuestos Technical Characteristics

    The TCL 20 Pro 5G smartphone is a device that stands out with wonderful features and advanced technology. Here are some key components, or "repuestos," of the phone:

    • Display: 6.67 inches, AMOLED
    • Resolution: 1080 x 2400 pixels
    • Battery: 4500 mAh, Non-removable Li-Po
    • RAM and Storage: 256GB 6GB RAM
    • Camera: Quad, 48 MP (wide angle) + 16 MP (ultra wide angle) + 2 MP (macro) + 2 MP (depth)
    • Front Camera: 32 MP, wide angle
    • Operating System: Android 11, TCL UI
    • Processor: Qualcomm SM7225 Snapdragon 750G 5G (8 nm)
    • Sim Slots: Hybrid Dual SIM

    Instructions for Replacing TCL 20 Pro 5G Repuestos

    Tools Needed

    You will need a SIM card ejector tool, small Phillips screwdriver, plastic pry tool, and a heat gun to carefully disassemble your TCL 20 Pro 5G phone.

    Step-by-step Guide

    • Switch off the phone: Power it down to prevent any inadvertent actions during the replacement process.
    • Remove the SIM card tray: Use the SIM card ejector tool and keep it aside safely.
    • Heat the back cover: Use a heat gun to slowly heat the edges of the back cover. This will soften the adhesive.
    • Prise the back cover: Use a plastic pry tool to gently lift the back cover off. Be careful not to apply too much force.
    • Remove screws: Unscrew the Phillips screws securing the plastic cover.
    • Lift the plastic cover: Use the pry tool again to remove the plastic cover, revealing the internal components of the phone.
    • Disconnect the battery: Carefully disconnect the battery connector. This step is necessary to prevent any short circuit during the repair process.
    • Replace the repuesto: Every component connected to the motherboard can be replaced. Unscrew and gently remove the faulty component, then set the new repuesto in place and screw it on where required.
    • Re-assembly: Follow the above steps in reverse order to reassemble your device. Ensure that all the screws are tightly secured.

    Proceed with caution during each step. If you don't feel comfortable after reading the instructions, it's recommended to take your phone to a professional service center or an experienced expert.

    Less
    More
    Showing 1 - 15 of 15 items