TP-link Neffos X1 Max spare parts

Technical Specifications of TP-link Neffos X1 Max

The TP-link Neffos X1 Max is a powerful smartphone from TP-link. Here are its specifications:

• Operating System: Android 7.0 (Nougat)
• Processor: Mediatek MT6755 Helio P10
• Screen Size: 5.5 inches
• Screen Resolution: 1080 x 1920 pixels
• RAM: 4GB
• Internal Storage: 64GB, expandable via microSD
• Camera: 13 MP, f/2.0 rear camera and 5 MP front-facing camera
• Battery: 2960 mAh

Instructions for Replacing TP-link Neffos X1 Max Repuestos

The process requires careful handling. Follow the instructions in order:

Step 1: Power off the Device

Turn off your TP-link Neffos X1 Max and make sure it’s disconnected from any charging source.

Step 2: Remove the Back Cover

Use a pry tool to unclip the cover at all edges until it’s completely detached.

Step 3: Disconnect the Battery Connector

This is located near the bottom on the right side. Use a nylon spudger to disconnect it from the motherboard.

Step 4: Remove the Battery

Remove the adhesive tape holding the battery to the phone’s chassis so you can lift it away.

Step 5: Unscrew and Replace the Desired Component

For each desired "repuesto" (replacement part), unscrew its holding screws, carefully remove the part, then place the new part and fasten it with the screws.

Step 6: Reassembly

Place back the battery, connect it to the motherboard, fit back the cover, and power on the device to check if it's functioning properly.

Note

Please be aware that any damages or warranty voids caused by self-troubleshooting or unauthorized modifications to your device are not covered by any service agreements.