Technical characteristics of Ulefone Armor 10 repuestos
The Ulefone Armor 10 repuestos, or replacement parts, are designed to maintain the high performance and durability of the device. The following are the key technical specifications:
- Screen: 6.67-inch Full HD+ IPS display, 2400 x 1080 resolution
- Battery: 5800mAh (Australian Plug),...
Technical characteristics of Ulefone Armor 10 repuestos
The Ulefone Armor 10 repuestos, or replacement parts, are designed to maintain the high performance and durability of the device. The following are the key technical specifications:
- Screen: 6.67-inch Full HD+ IPS display, 2400 x 1080 resolution
- Battery: 5800mAh (Australian Plug), supports 15W wireless charging
- Camera: Quad rear camera, 64MP Main camera + 8MP wide-angle + 5MP macro + 2MP sub-camera. Front camera of 16MP
- Processor: MediaTek Dimensity 800 5G chipset
- RAM & Storage: 8GB RAM, 128GB ROM, expandable up to 1TB
Instructions on how to replace Ulefone Armor 10 repuestos
Be sure to switch off your device and remove the battery, if possible, before working with any internal components. Follow these steps to replace parts:
Screen replacement
To replace the screen on your Ulefone Armor 10, follow these steps:
- Use a precision screwdriver to remove the screws holding the back cover.
- Carefully pry off the back cover using a plastic opening tool.
- Disconnect the screen connector cable from the motherboard.
- Remove the damaged screen and replace it with a new one.
- Be sure to reconnect the screen connector cable before replacing the back cover and screws.
Battery replacement
Here’s how to replace the Battery:
- After removing the back cover as described before, locate the battery.
- Disconnect the battery connector from the motherboard.
- Remove the old battery and replace it with a new one, ensuring the connector is properly secured.
Camera replacement
If you need to replace the camera on your Ulefone Armor 10, please follow these steps:
- First, remove the back cover and locate the camera module.
- Detach the camera’s connector cable, then cautiously remove the old camera module.
- Place the new camera, connect the connector cable and finally replace the back cover.
Remember to handle all components with care to avoid any accidental damage. It is often recommended to get professional help for hardware replacements.
Less