Vernee M6 spare parts

Technical Characteristics of Vernee M6 Repuestos

The Vernee M6 repuestos, or spare parts, encompass several critical components that contribute to the optimal functioning of the device. Here are some of the key technical features:

• Screen: It comes with a 5.7-inch High Definition (HD) IPS, LCD capacitive touchscreen with 1440 x 720 pixels resolution.
• Battery: The replacement battery is a Lithium-ion polymer unit with a capacity of 3300mAh.
• Camera: The replacements include a 13MP rear camera module and an 8MP front-facing camera module.
• Motherboard: The motherboard carries an MT6750C, Octa-core processor, operating at 1.5GHz and an ARM Mali T860 MP2 GPU.

Instructions for Replacing Vernee M6 Repuestos

Disclaimer: This process should be done by a professional or under professional guidance. Improper handling of the device may cause damage.

Screen Replacement

Here's how to replace the M6 screen:

• Switch off the device and remove the SIM card tray and SD card tray.
• Warm the edges of the screen to soften the adhesive that binds the screen to the frame.
• Use a special tool, such as a plastic pick or a card, to carefully separate the display from the frame.
• Gently pull up the screen and disconnect the display cable. Remember to unscrew any screws if there are any connecting the display cable.
• Mount the new screen, make sure to reconnect the display cable, and firmly press around the edges for a firm seal.

Battery Replacement

Follow these steps to replace the battery:

• Shut down the device and remove the back panel of the phone.
• Disconnect the battery connector from the motherboard.
• Remove any screws holding the battery and carefully lift the battery out.
• Place the new battery, reconnect the battery connector to the motherboard, and screw in any screws (if applicable).
• Reassemble the back panel of the device.

Camera Replacement

Here's how to replace the Camera:

• Turn off the device and remove the back cover.
• Disconnect the camera connector from the motherboard.
• Once disconnected, unscrew any screws holding the camera module and lift it out.
• Install the new camera module, reconnect the camera connector and re-screw it back.
• Place the back cover back on the device.

Remember, fixing the phone on your own can save cost, but it can also lead to injuring yourself or damaging your phone if not done carefully.