Wiko Jerry 3 spare parts

Technical Characteristics of Wiko Jerry 3 Repuestos

The Wiko Jerry 3 repuestos form an essential part of the hardware configuration of the Wiko Jerry 3 smartphone. Here are some of the core components:

• Screen: 5.45" FWVGA+ Display, 960 x 480 pixels resolution.
• Battery: 2500mAh Li-Po, non-removable.
• Rear Camera: 5MP sensor with LED flash.
• Front Camera: 5MP sensor.
• Processor: Quad-Core 1.3 GHz, Cortex-A7.
• Memory: 16GB ROM + 1GB RAM, expandable up to 64GB with a micro SD card.

Instructions for replacing Wiko Jerry 3 repuestos

Please ensure that you have the correct repuestos at hand and the necessary tools before you commence.

Screen Replacement

• Switch off the phone and remove the SIM tray.
• Use a heat gun to loosen the adhesive securing the screen.
• With a prying tool, carefully lift the screen from the edges.
• Detach the connector (ribbon) fastening the screen to the motherboard.
• Attach the new screen using its connector and press down the edges to firmly put it in place. Turn on your smartphone to test the functionality of the new screen.

Battery Replacement

• Switch off your Wiko Jerry 3 smartphone and remove the back cover.
• Remove the screws holding the battery place, and carefully lift the battery.
• Detach the battery connector from the mainboard.
• Connect the new battery and place it correctly, then replace the screws and the back cover. Turn on your smartphone to test the new battery.

Camera Replacement

• Switch off your Wiko Jerry 3 smartphone and remove the back cover.
• Locate the camera module and unfasten its connector.
• Remove the faulty camera and replace it with the new one, make sure to secure the connector properly.
• Place the back cover and test the functionality of the new camera.

Please handle your device with care, and if you're unsure or unconfident about any of these procedures, it's recommended to consult professional help.