Xiaomi Redmi 9A spare parts

Xiaomi Redmi 9A Repuestos Technical Characteristics

The Xiaomi Redmi 9A is a popular smartphone equipped with the following replacement parts, or repuestos:

• Display: 6.53 inches, 720 x 1600 pixels, IPS LCD
• Processor: MediaTek Helio G25 (12 nm)
• RAM: 2GB/3GB
• Storage: 32GB/64GB, expandable via microSDXC
• Battery: Non-removable Li-Po 5000 mAh battery
• Rear Camera: 13 MP, f/2.2, 28mm (wide), 1.0µm, PDAF
• Front Camera: 5 MP, f/2.2, (wide), 1.12µm
• OS: MIUI 12, upgradable to MIUI 12.5

Replacement Instructions for Xiaomi Redmi 9A Repuestos

Disclaimer

Please note that following these instructions is at your own risk. The manufacturer will not be responsible for any damages that might occur. It's highly recommended to be conducted by a professional technician.

Preparation

Before you start, make sure to power off your device and remove the SIM card tray.

Step 1: Open the device

Use a professional phone opening tool to carefully separate the back cover from the rest of the device.

Step 2: Disconnect the battery

Once inside, locate the battery connector and gently disconnect it from the motherboard.

Step 3: Remove the old part

Depending on the part you're replacing, you might need to remove some screws and disconnect further wires. Do this carefully, noting the position of each part for easier reassembly.

Step 4: Install the new part

Place the new part in the designated position and connect any necessary wires. If screws were removed, reinsert them now.

Step 5: Reassemble the phone

Reconnect the battery and carefully position the back cover onto the device. Apply gentle pressure until it clicks into place.

Step 6: Test the phone

Switch on your device and test its functionality to confirm the replacement was successful.