Xiaomi Redmi Note 12 Pro 5G spare parts

Xiaomi Redmi Note 12 Pro 5G Repuestos - Technical Specifications

The Xiaomi Redmi Note 12 Pro 5G is a versatile device with an array of high-end specifications. When it comes to replacing parts, or 'repuestos', specific technical knowledge is required. Here is a brief overview of its key specifications:

• Display: 6.9 inches, 1080x2400 pixels, AMOLED
• Battery: Li-Po 5000 mAh, non-removable
• Rear Camera: Quad Camera system, 108+8+5+2 MP
• Front Camera: 16 MP
• Processor: Qualcomm Snapdragon 732G
• RAM: 8GB
• Memory: 128GB/256GB storage, microSDXC
• Operating System: Android 11, MIUI 12.5

Instructions for Replacing Repuestos

Disassembling or repairing your device can void your warranty. If you choose to proceed, it's important to remember to be gentle during the process to avoid damaging any parts. Below are instructions for general component replacements:

Tools Needed

• Small Phillips Screwdriver
• Spudger (or any thin, prying tool)
• Small suction cup
• Plastic cards and picks

Preparation

Before starting, make sure your work area is clean and well-lit. It’s also recommended to make a guide of all the screws and components you remove to keep track of their original location.

Procedure

1. Power off the device.
2. Remove the SIM card tray.
3. Use a heat gun or hair dryer to loosen the adhesive on the edges of the screen. Apply little heat at a time to avoid damaging the device.
4. Attach the suction cup to the heated surface, lift slightly, and insert plastic cards or picks to prevent the adhesive from resealing.
5. Move the cards along the edges of the phone to break up the rest of the adhesive.
6. Carefully separate the screen from the rest of the phone, make sure to disconnect any flex cables that may tear.
7. Remove the appropriate screws and brackets covering the part you wish to replace.
8. Disconnect the flex cable connecting the part to the motherboard, then remove the part.
9. Place the new part in the phone and reverse the steps to reassemble the device.

Note: Always be gentle when working with electronic parts. Forceful handling can cause damage to components. If something does not fit or attach easily, double-check its positioning before proceeding.