ZTE Nubia Red Magic 6S Pro spare parts

ZTE Nubia Red Magic 6S Pro Technical Specifications

• Display: 6.8 inches AMOLED, 1B colors, 165Hz, HDR10+
• Resolution: 1080 x 2400 pixels, 20:9 ratio (~388 ppi density)
• OS: Android 11, Redmagic 4.0
• Chipset: Qualcomm SM8350 Snapdragon 888+ 5G (5 nm)
• Memory: UFS 3.1 128GB 8GB RAM, UFS 3.1 256GB 12GB RAM, UFS 3.1 256GB 16GB RAM
• Battery: Li-Po 5050 mAh, non-removable
• Camera: 64 MP, f/1.8, 26mm (wide), 1/1.72", 0.8µm, PDAF

Instructions for replacing ZTE Nubia Red Magic 6S Pro Repuestos

Tools Needed

• Small Philips Screwdriver
• Plastic Opening Tools
• Tweezers
• Hot Air Gun / Heat Gun
• Suction Cup

Procedure

IMPORTANT: Please switch off your device before starting the replacement process.

Step 1: First, use a heat gun to gently warm up the adhesive that sticks the back cover to the phone body.

Step 2: Use the suction cup to create a small separation between the back cover and the phone body. Then, insert a plastic opening tool into the gap to pry open the back cover. Be gentle to avoid any damage.

Step 3: With the back cover removed, you will see many screws securing the interior parts. Use your Philips screwdriver to remove these screws.

Step 4: Carefully remove the battery connector and the screen connector from the motherboard.

Step 5: Remove the faulty parts (like battery or screen) and replace them with the new ones.

Step 6: Reconnect the battery and screen connectors to the motherboard.

Step 7: Replace all the screws you initially removed. Make sure everything is tight and secure.

Step 8: Finally, reattach the back cover and ensure it fits properly. You may need to heat it slightly to activate the adhesive.

Note: If you're not confident in your abilities to perform these actions, it's recommended to seek help from a professional. Keep in mind that any damage caused during repair might void your warranty.