ZTE Nubia V18 NX612J spare parts

ZTE Nubia V18 NX612J Repuestos – Technical Characteristics

The ZTE Nubia V18 NX612J is a smartphone device that comes with a number of distinguishable features. Being mindful of these characteristics is key to effectual smartphone repair and part replacement.

• Screen Size: 6.01 inches, 92.9 cm2 (~78.2% screen-to-body ratio).
• Resolution: 1080 x 2160 pixels, 18:9 ratio (~402 ppi density).
• Operating System: Android 7.1.1 (Nougat), MiFavor 5.1.
• Processor: Qualcomm Snapdragon 625.
• Storage: 64GB 4GB RAM.
• Camera: Main Camera: 13 MP, Front Camera: 8MP.
• Battery: Non-removable Li-Po 4000 mAh battery.

Instructions for Replacing ZTE Nubia V18 NX612J Repuestos

Here are some detailed step-by-step instructions on replacing parts of the ZTE Nubia V18 NX612J.

Disclaimer

Make sure to handle all parts with care. Any damage caused due to mishandling is not covered under warranty. Proceed at your own risk.

Tools You'll Need

• A set of smartphone repair tools, including a pentalobe screwdriver.
• A plastic pry tool.
• A suction cup.

Step-by-step Procedure

Step 1: Power Off the Device

Switch off the smartphone to prevent any electrical damage during the repair process.

Step 2: Remove the SIM Card Tray

Extract the SIM card tray using the ejector tool provided in your smartphone repair kit.

Step 3: Remove the Back Cover

Use a heat gun or hairdryer to slightly warm up the edges of the back cover. This helps in loosening the adhesive. Attach a suction cup towards the bottom of the back cover, apply some upward force to create a gap, and then use a plastic pry tool to increase this gap. Move the pry tool along the edges to unstick the adhesive.

Step 4: Disconnect and Replace the Necessary Part

After opening the back cover, locate the defective part you wish to replace. Use the necessary screwdriver to remove it. Replace it with the new part and make sure it is properly connected.

Step 5: Reassemble the Phone

Start by reconnecting the back cover to the body. Make sure it is firmly placed. Finally, screw back in any previous screws removed and insert the SIM card.

Step 6: Power On the Device

Turn on the device and check the functionality of the replaced part.