Acer Iconia One 7 B1-780 spare parts

Acer Iconia One 7 B1-780 Repuestos Technical Characteristics

The Acer Iconia One 7 B1-780 is a dynamic tablet with vast features. This device makes use of a variety of components, some of which are easily replaceable and repairable. The key technical characteristics of these repuestos (components) are as follows:

• Screen: The device uses a 7-inch IPS LCD with a resolution of 1280x720 pixels.
• Battery: The device is powered by a non-removable Lithium Polymer battery.
• Processor: It comes with a Mediatek MT8127 Quad-core 1.3 GHz processor.
• Memory: The device includes 1GB RAM and supports external storage via microSD, up to 32 GB.
• Camera: The tablet features a 2MP rear camera and a 0.3MP front camera.

Instructions for Replacing Acer Iconia One 7 B1-780 Repuestos

Before attempting to replace any components, ensure the device is switched off and disconnected from any power source.

Replacing the Screen

To replace the screen of Acer Iconia One 7 B1-780, follow these steps:

• Using a small suction cup, gently pull on the scratch-resistant glass until it separates from the tablet body. Be careful not to apply too much pressure as it may crack the glass.
• Remove the screen connector from the motherboard. Replace the old screen with the new one and reconnect it.
• Gently push the new screen into the tablet frame until it perfectly fits in place.

Replacing the Battery

To replace the battery module of your Acer Iconia One 7 B1-780, follow the steps mentioned below:

• Pry open the back cover of the tablet using a plastic pry tool.
• Once the cover is removed, you will see the battery. Disconnect the battery connector from the motherboard.
• Lift the battery out and replace it with a new one. After placing the new battery, reconnect the battery connector to the motherboard.
• Reattach the back cover to complete the replacement process.

Replacing the Memory

To replace or upgrade the external memory of your Acer Iconia One 7 B1-780, perform these steps:

• Locate the microSD slot on the side of the device.
• Push the existing card into the slot until it clicks and releases. Remove the card.
• Insert the new microSD card into the slot until it clicks into place.

Note

While replacing components, always ensure to use compatible parts. Replacement of any component should be performed in a clean and static-free environment to prevent damage to the new or existing parts.