Alcatel 1T 10" 8082 spare parts

Technical Characteristics of Alcatel 1T 10" 8082 Repuestos

The Alcatel 1T 10" 8082 is a tablet with a range of notable technical features.

• Screen Size: 10.1 inches
• Resolution: 1280 x 800 pixels
• Operating System: Android 8.0 Oreo
• Processor: MediaTek MT8321A/D
• RAM: 1GB
• Storage: 16GB, expandable up to 128GB
• Battery: 4000mAh

Instructions on How to Replace Alcatel 1T 10" 8082 Repuestos

The replacement of parts in Alcatel 1T 10" 8082 must be carried out with care. Adequate tools are required for the task to avoid damaging the device. Here's a step-by-step guide:

Tools Required

• Small Phillips Screwdriver
• Pry tool or Spudger
• Heat Gun or Hairdryer

Steps

Before going ahead, ensure to turn off the tablet and disconnect any cables attached to it for safety reasons.

1. Using the heat gun or hair dryer, gently warm up the edges of the screen to loosen the adhesive holding it in place.
2. Insert the pry tool or spudger between the screen and the frame at one corner and gently lift it to separate the screen from the frame.
3. Once the screen is separated, you will see the screws holding the internal parts in place. Use your Phillips screwdriver to remove these screws, careful to keep them in a safe location.
4. Carefully lift the covers to expose the parts you wish to replace. This may include the battery, the storage, etc. It is recommended to take a picture before removing anything to remember the original layout.
5. Replace the old parts with the new ones, and carefully plug in any connectors or cables as was originally done.
6. Once all parts are replaced, re-attach the covers and re-insert the screws.
7. Finally, re-attach the screen to the frame. Heat may be applied again to allow the adhesive to bond.