Blackview Tab 10 spare parts

Technical Characteristics of Blackview Tab 10 Repuestos

The Blackview Tab 10 Repuestos is a robust set of replacement pieces for the Blackview Tab 10 tablet. Their unique features enhance the longevity and flexibility of the tablet drastically.

• Screen: A significant component of the repuestos is the high resolution 10.1-inch IPS display with a resolution of 1200 x 1920 pixels.
• Battery: The repuestos include a powerful, enduring 7480mAh Li-Po battery.
• Camera Units: The repuestos offer a 13MP rear camera and a 5MP front camera for clear imaging.
• Motherboard: Includes a robust motherboard designed specifically for the Blackview Tab 10.

Instructions for Replacing Blackview Tab 10 Repuestos

Warning

Proceed with caution because incorrect handling may damage the components. Ensure the device is not connected to a power source before starting.

Screen Replacement

• Power off your Blackview Tab 10.
• With a thin, soft tool, gently pry open the screen from the bottom edge.
• Unscrew and detach the old screen carefully, noting the positioning of cables.
• Replace the screen with the new one and gently fasten it back into place. Be careful to replace the cables as they were with the old screen.

Battery Replacement

• After removing the screen, you should see the battery connected to the lower part of the device.
• Disconnect the battery, avoiding pulling on the cable directly to prevent damage.
• Replace the battery with the new one and reconnect the cable.

Camera Replacement

• Remove the back panel of the device following the method used to remove the screen.
• Detach the old camera unit from the motherboard by gently unscrewing it and disconnecting the cables.
• Install the new camera onto the motherboard, being careful to connect the right cables to the right connectors.

Motherboard Replacement

• After removing the back panel and disconnecting the battery, locate the motherboard.
• Disconnect all connected peripherals and detach the motherboard by unscrewing it.
• Replace the old motherboard with the new one. Reconnect all peripherals as with the old board.

Note: Always power on the device and confirm functionality after each replacement.