IPad 7ª Generation 2019 A2197 Wifi A2200 A2198 Wifi,GSM spare parts

iPad 7ª Generacion 2019 A2197 Wifi A2200 A2198 Wifi,GSM Repuestos Technical Characteristics

The iPad 7ª Generacion 2019 comes in three different models - the A2197 (Wifi), A2200, and A2198 (Wifi, GSM).

• Display: 10.2 inches, 2160 x 1620 pixel resolution
• Processor: Apple A10 Fusion
• RAM: 3GB
• Storage: 32GB and 128GB options
• Camera: 8 MP rear camera, 1.2 MP front camera
• Connectivity: Wifi, Bluetooth 4.2, GSM for the A2198 model
• Battery: 8827 mAh

Replacement Instructions

The instructions below provide a detailed step-by-step guide on how to replace spare parts on the iPad 7ª Generacion 2019 models.

Step 1: Removing the Screen

Start by turning off your iPad completely. Warm up the edges of the screen with a heating tool to soften the adhesive. Use a suction cup and plastic opening tool to carefully lift the screen, starting from one of the bottom corners. Be careful not to fully detach the screen as it is still connected by several cables.

Step 2: Disconnecting the Battery

Detach the connector shield by removing the five screws. Unplug the battery connector using a non-conductive tool.

Step 3: Removing the Display Assembly

Remove the additional screws securing the screen connectors, then gently disconnect the screen and remove it completely.

Step 4: Replacing the Spare Part

Whether you're replacing a battery, a camera, or other part, always ensure that the replacement part is specific to your iPad model. Carefully remove any adhesive residue and apply new adhesive where necessary before installing the new part.

Step 5: Reassembly

Connect the new part and reassemble your iPad using the steps above in reverse order. Make sure all screws are returned to their original positions and all connections are secure.

Note: iPad repair should always be done with the right tools and sufficient knowledge. If you are unsure about any step, it's better to consult with a professional.