Microsoft Surface Pro 5 spare parts

Microsoft Surface Pro 5 Technical Characteristics

The Microsoft Surface Pro 5, also known as the Microsoft Surface Pro (2017), is a highly regarded 2-in-1 hybrid computer with a number of impressive repuestos or replacement parts. Below are some of the technical characteristics for these key components:

• Screen: 12.3" PixelSense Display, Resolution: 2736 x 1824 (267 PPI), Aspect Ratio: 3:2.
• Processor: Intel 7th Gen Core m3, i5, i7
• Memory: 4GB, 8GB or 16GB RAM options.
• Storage: Solid-state drive (SSD) options: 128GB, 256GB, 512GB, or 1TB.
• Battery: Up to 13.5 hours of video playback.

Instructions for Replacing Microsoft Surface Pro 5 Repuestos

Note: Replacing parts of your Microsoft Surface Pro 5 requires a certain level of technical skill. Proceed with caution and at your own risk.

Screen Replacement

• Begin by powering off the Surface Pro 5.
• Apply a heat gun or a similar tool around the edges of the screen to weaken the adhesive.
• Using a plastic pry tool, carefully lift the screen. Make sure to do this slowly to prevent any damage.
• Once the screen is separated from the case, carefully disconnect the screen cable.
• Connect the new screen, place it correctly within the frame, and apply adhesive where required.

Battery Replacement

• After removing the screen as per above steps, locate the battery compartment.
• Disconnect the battery connector from the motherboard.
• Remove the screws that are holding the battery in place.
• Carefully lift the battery out of its compartment.
• Place the new battery in, reconnect it to the motherboard, and screw it back in place.
• Reconnect the screen, ensuring all connections are secure.

SSD Replacement

• To replace the SSD, you need to remove the screen and the battery, following the steps above.
• Locate the SSD on the motherboard and remove the screws securing it in place.
• Lift out the SSD carefully, and replace it with the new one.
• Reassemble your Surface Pro 5 by reversing the disassembly steps.

Please, make sure that the device is powered off before starting any replacement process and wear an antistatic wrist strap to prevent electrostatic discharge (ESD) damage.