Microsoft Surface Pro 7 Plus spare parts

Technical Characteristics of Microsoft Surface Pro 7 Plus Repuestos

The Microsoft Surface Pro 7 Plus Repuestos are integral parts that facilitate optimum performance of the hardware. Here are the technical characteristics:

• Display: A 12.3" PixelSense™ Display, with resolution - (2736 x 1824) 267PPI.
• Processor: 11th Gen Intel® Core™ i5-1135G7 or i7-1165G7.
• Memory: Available in variants of 8GB or 16GB LPDDR4x RAM.
• Storage: 128GB, 256GB, 512GB, or 1TB SSD.
• Battery: Up to 15 hours of typical device usage.

Instructions for Replacing Microsoft Surface Pro 7 Plus Repuestos

Caution: Proceed with the steps below only if you have experience in handling electronic equipment repairs, as improper handling can result in irreparable damage.

1. Preparation

• Power Off: Ensure the Surface Pro 7 Plus is switched off to prevent short circuits.
• Clean Workspace: Prepare a clean, clutter-free workspace with good lighting.

2. Disassembly

• Remove the Kickstand: Open the kickstand and use an appropriate tool to remove it.
• Screen Removal: Use a heat gun to loosen the adhesive around the screen then carefully lift it up using an appropriate prying tool. Be careful of the LCD flex cable attached to the motherboard.

3. Replacing the Repuesto Part

• Component Removal: Depending on the repuesto part you are replacing, carefully disconnect it from the motherboard. Take note of any screws and their positions to enable easy reassembly.
• Replacement: Replace the old part with the new one. Ensure it is correctly seated and any connectors are securely attached.

4. Reassembly

• Reinstall the Screen: Carefully reconnect the LCD flex cable to the motherboard and sit the screen back in its original position. Heat the edges to reactivate the adhesive.
• Reinstall the Kickstand: Place the kickstand back in position and screw it back into place.
• Device Boot: Turn on your Surface Pro 7 Plus to test if the new part is correctly installed and functioning as expected.