Adhesives kit by Samsung Galaxy S26 Plus SM-S947 GH82-39221A Service Pack

The Service Pack adhesive kit GH82-39221A for Samsung Galaxy S26 Plus SM-S947, compatible with variants SM-S947B, SM-S947B/DS and SM-S947U, is designed to renew the attachment of the back cover or battery cover. Identified by the technical designation A/S REPAIR KIT-B/C (COMM), it contains adhesive elements specifically intended for mounting the rear cover. It allows adhesive deteriorated during disassembly to be replaced and restores the bond between the cover and chassis. It is suitable for workshops and professional repair services performing battery replacements, internal repairs or procedures requiring removal and reinstallation of the rear cover.

- Brand: Samsung.

- Compatible model: Samsung Galaxy S26 Plus 5G.

- Compatible technical models: SM-S947B, SM-S947B/DS and SM-S947U.

- Part Number: GH82-39221A.

- Samsung technical designation: A/S REPAIR KIT-B/C (COMM).

- Component type: Back cover or battery cover adhesive kit.

- Included components: Fixing adhesives for the rear cover.

- Application: Attachment of the back cover to the device chassis.

- Function: Renewal of adhesive elements used during rear cover installation and closure.

- Quality: Samsung Service Pack.

The Service Pack adhesive kit GH82-39221A allows the Samsung Galaxy S26 Plus back cover attachment to be renewed after a technical repair. Its specific design for this model facilitates adhesive positioning on the corresponding contact surfaces, promoting uniform seating of the rear cover.

Its use is particularly practical during battery replacements, connector repairs or procedures requiring phone disassembly and removal of the existing adhesive.

Samsung part number GH82-39221A facilitates identification of the appropriate kit and distinguishes it from adhesives intended for display installation.

For repair workshops and professional technicians, it provides a maintenance solution that allows assembly to be completed using new fixing elements without reusing deteriorated adhesives.

- Turn off the device, disconnect the battery and use ESD protection before starting the repair.

- Carefully remove the back cover using suitable tools and controlled heat to soften the existing adhesive.

- Completely remove previous adhesive residue from both the chassis and the inner surface of the cover.

- Clean and degrease the contact surfaces to facilitate uniform attachment.

- Check the arrangement of the kit adhesives before starting installation.

- Install the new adhesive elements following their correct orientation and alignment with the mounting surfaces.

- Remove the protective films according to the application sequence while avoiding contact with the adhesive surfaces.

- Check the operation of repaired components before completing the final device closure.

- Position the back cover, verify its alignment with the frame and complete installation without displacing the adhesives.

- Apply uniform pressure for approximately 20-30 minutes when appropriate according to the specifications of the adhesive used.

- Check that the cover is fully seated and that the perimeter attachment is continuous before completing the repair.