Back cover or battery cover black trim by Ulefone RugKing 4 Pro

Black back cover or battery cover trim for Ulefone RugKing 4 Pro

Black rear trim for Ulefone RugKing 4 Pro, designed to replace the exterior finishing part located in the back cover or battery cover area when it has breaks, impacts, deformations or significant cosmetic deterioration. This replacement part makes it possible to renew the rear finish of the device without the need to replace other components that remain in good condition. It is specifically intended for the Ulefone RugKing 4 Pro and designed for professional installation, previously checking the position, fixing points and fit before final assembly.

Specifications

Trim for the back cover or battery cover area.

Black color.

Compatible with Ulefone RugKing 4 Pro.

Replacement part intended for the exterior finish of the rear of the device.

It does not correspond to a complete back cover unless expressly indicated in the product.

This trim makes it possible to restore the exterior finish of the Ulefone RugKing 4 Pro when the installed part has scratches, breaks, deformations or damage caused by impacts. Its replacement is especially useful when the main housing remains in good condition and only the affected exterior element needs to be renewed. It is prepared to integrate into the corresponding rear structure of the device and facilitate a localized repair, avoiding unnecessary replacement of complete assemblies. Before final installation, it is recommended to compare the removed part with the new replacement, check all fixing points and verify that it does not interfere with cameras, sensors, buttons or other rear elements.

Installation tips

Disconnect the battery before starting the repair.

Use ESD protection and suitable tools during disassembly.

Remove the previous trim without damaging the housing underneath.

Completely remove any adhesive residue or dirt from the mounting surface.

Position the part without fixing it and check all fitting points.

Verify that cameras, sensors and other rear elements are correctly positioned.

Use new adhesives when necessary.

Perform a complete check before final assembly.

Notice

This product corresponds to the exterior trim of the rear area and should not be confused with the complete back cover or housing of the device. It is recommended to physically compare the part before removing adhesives or performing the final installation.

Technical table