Battery BLP699 4000mAh by Oneplus 7 Pro GM1910 1031100009 Service Pack

 The BLP699 4000 mAh battery for OnePlus 7 Pro GM1910, GM1911, GM1913, GM1915 and GM1917, as well as OnePlus 7 Pro 5G GM1925, is a Service Pack replacement identified by part number 1031100009. It is designed to replace the internal battery when it experiences reduced battery life, rapid discharge, difficulty holding a charge or unexpected shutdowns related to battery wear. Its typical capacity of 4000 mAh and nominal voltage of 3.85 V correspond to the specifications of this battery model. It is suitable for professional repairs requiring a correctly identified component appropriate for each variant.

- Brand:OnePlus.

- Battery model:BLP699.

- Manufacturer part number (Part No):1031100009.

- Typical capacity:4000 mAh.

- Rated capacity:3880 mAh.

- Nominal voltage:3.85 V.

- Typical energy:15.40 Wh.

- Rated energy:14.93 Wh.

- Technology:Lithium-ion polymer (Li-ion Polymer).

- Component type:Rechargeable internal battery.

- Compatible models:OnePlus 7 Pro and OnePlus 7 Pro 5G.

- OnePlus 7 Pro technical models:GM1910, GM1911, GM1913, GM1915 and GM1917.

- OnePlus 7 Pro 5G technical model:GM1925.

- Quality:Service Pack.

 The BLP699 Service Pack battery helps restore the battery life of the OnePlus 7 Pro when the previous battery has lost capacity through use. Its typical capacity of 4000 mAh, rated capacity of 3880 mAh and voltage of 3.85 V allow technicians to verify the replacement's electrical parameters before installation. Part number 1031100009 helps distinguish this component from batteries used in other OnePlus models, preventing replacements based solely on appearance. Its application in variants GM1910, GM1911, GM1913, GM1915 and GM1917, as well as the 5G version GM1925, increases its usefulness in workshops repairing devices from different markets. Proper installation and verification allow technicians to assess the operation of the power system after the repair.

- Switch off the device completely before starting and use electrostatic discharge (ESD) protection.

- Reduce the installed battery charge below 25% before disassembly to minimise risks during handling.

- Disconnect the battery before removing it, avoiding punctures, deformation or damage to its casing.

- Check that the BLP699 reference and connector match those of the removed battery.

- Position the new battery in its housing and carefully connect the flex cable without forcing the contacts.

- Remove any remaining old adhesive and use suitable fixing adhesive to secure the battery.

- Check device startup, battery recognition, charge percentage and charging system operation before closing the device.

- Perform a calibration cycle when necessary to stabilise the battery percentage reading.

- Replace the rear cover sealing adhesive and verify that it is correctly secured. Take the removed battery to an authorised recycling facility.