Battery BP4K 5000mAh by Xiaomi Redmi Note 12 Pro 5G Poco X5 Pro Poco F5 46020000EHLM Service Pack

The BP4K battery for Xiaomi Redmi Note 12 Pro 5G 22101316G, POCO X5 Pro 5G 22101320G and POCO F5 5G 23049PCD8G is an original Service Pack replacement, identified by part number 46020000EHLM. It is also compatible with their regional variants and the Redmi Note 12 Turbo 23049RAD8C. It features a typical capacity of 5000 mAh, a rated capacity of 4900 mAh and a voltage of 3.87 V. It allows the replacement of deteriorated batteries experiencing reduced battery life, rapid discharge, charging problems or unexpected shutdowns, while maintaining the electrical characteristics of the original component.

- Brand:Xiaomi.

- Battery model:BP4K.

- Part number (Part No):46020000EHLM.

- Typical capacity:5000 mAh.

- Rated capacity:4900 mAh.

- Nominal voltage:3.87 V.

- Typical energy:19.3 Wh.

- Technology:rechargeable lithium-ion battery (Li-ion).

- Component type:internal battery with integrated flexible connection.

- Xiaomi Redmi Note 12 Pro 5G:22101316G, 22101316I, 22101316C and 23013RK75C.

- Xiaomi POCO X5 Pro 5G:22101320G and 22101320I.

- Xiaomi POCO F5 5G:23049PCD8G and 23049PCD8I.

- Xiaomi Redmi Note 12 Turbo:23049RAD8C, China version.

- Quality:original Xiaomi Service Pack.

The Xiaomi BP4K Service Pack battery helps restore device battery life when the installed battery has deteriorated due to use and accumulated charging cycles. Its typical capacity of 5000 mAh and nominal voltage of 3.87 V maintain the power supply specifications designed for compatible models.

As an original Service Pack replacement, it retains the format and connections corresponding to the factory-installed battery, facilitating integration into the phone's internal compartment.

Its compatibility with different Redmi Note and POCO series models allows the same part number to be used across several professional repairs, simplifying component identification and spare parts management in the workshop. It is a suitable solution for replacing deteriorated batteries and restoring normal device operation.

- Switch off the phone and disconnect the battery before handling internal components, using electrostatic discharge (ESD) protection.

- Carefully remove the previous battery and clean adhesive residue from the battery compartment.

- Position the BP4K battery correctly, aligning the connector and avoiding excessive tension or bending of the flex cable.

- Check device power-on, battery recognition and charging operation before final closure.

- Use suitable fixing adhesive and check that the battery is correctly seated in its compartment.

- Check the battery percentage and perform a normal charging cycle to verify operation and reading calibration.

- Close the rear cover using appropriate adhesive, checking its alignment and the device seal.