Battery QE50 5000mAh by Motorola Moto G85 XT2427-3 SB18E14178 SB18E14179 Service Pack

Battery QE50 5000mAh for Motorola Moto G85 XT2427-3 (XT2427-3) SB18E14178 / SB18E14179 Service Pack

The QE50 5000mAh Service Pack battery for Motorola Moto G85 (XT2427-3) is designed to restore the device’s original autonomy, energy stability and performance. This module includes part numbers SB18E14178 and SB18E14179, ensuring direct compatibility with the technical model and precise fitting inside the internal compartment. Its optimised chemistry provides extended charge cycles, low degradation over time and stable power delivery even under intensive use. Thanks to factory assembly, it maintains exact tolerances, firm connectors and solid internal protection that reduces installation risks and prevents failures caused by uncalibrated modules. It is a replacement aimed at professional repair shops requiring durability, reliability and safe installation. Cold testing before closure and a full initial charge are recommended to stabilise percentage accuracy.

Key features
• Factory-assembled battery with high thermal stability
• Compatible with Motorola Moto G85 (XT2427-3)
• Nominal capacity 5000mAh
• Reference QE50 with Part Numbers SB18E14178 / SB18E14179
• Chemistry optimised for long life and low degradation
• Robust connectors and factory tolerances
• Designed for safe, precise professional repairs

Advantages and quality
The Service Pack quality ensures controlled charging parameters, reinforced internal protection and full compatibility with the Moto G85 power-management system. Its construction reduces premature degradation, improves fast-charge efficiency and maintains thermal stability under continuous use. For workshops, this module reduces post-repair issues, allows safe assembly and provides a durable, professional finish. Consistent energy delivery improves daily autonomy and prevents issues common with uncalibrated or low-quality batteries. Available for immediate shipping from Spain.

Installation tips

1. Fully disconnect the device from power before handling.

2. Remove old adhesive and apply new adhesive strips.

3. Install the battery without bending or applying excessive pressure.

4. Check connectors, flex and sensors before closing.

5. Perform a full initial charge to stabilise percentage readings.

6. Monitor temperature and consumption during the initial minutes after repair.

Technical table