Battery QM50 5000mAh by Motorola Edge 40 Neo XT2307 SB18D87943 Service Pack

The QM50 battery for Motorola Edge 40 Neo, models XT2307-1, XT2307-2 and XT2307-3, is a Service Pack replacement part identified by reference SB18D87943. Manufactured using lithium-ion polymer technology, it offers a typical capacity of 5000 mAh and a nominal voltage of 3.91 V. It is designed to replace deteriorated batteries when the device experiences reduced battery life, unexpected shutdowns or difficulties maintaining its charge. Its specific configuration enables repairs to the power supply system while preserving the electrical characteristics intended for this model, both in professional technical services and refurbishment operations.

- Brand:Motorola.

- Compatible model:Motorola Edge 40 Neo.

- Technical models:XT2307-1, XT2307-2 and XT2307-3.

- Battery model:QM50.

- Part Number (Part No):SB18D87943.

- Typical capacity:5000 mAh.

- Rated capacity:4850 mAh.

- Nominal voltage:3.91 V.

- Technology:lithium-ion polymer (Li-Polymer).

- Component type:rechargeable internal battery.

- Connection:via battery flex cable and connector.

- Quality:Service Pack.

Reference SB18D87943 enables precise identification of this QM50 battery for the XT2307 variants of the Motorola Edge 40 Neo, making replacement part selection easier in the workshop. Its typical capacity of 5000 mAh maintains the value intended for this component, while its nominal voltage of 3.91 V corresponds to the device's electrical configuration. The internal format and flex cable connection system allow the worn battery to be replaced without modifying the device's design. As a Service Pack replacement part, it is intended for repairs that seek to preserve the manufacturer's power supply characteristics. Its installation allows battery life to be restored when reduced performance results from battery deterioration, extending the phone's useful life and avoiding replacement of the entire device.

- Switch off the Motorola Edge 40 Neo, disconnect the battery and use ESD antistatic protection during the repair.

- Remove the back cover and access the battery compartment using appropriate disassembly tools.

- Remove the installed battery and clean any remaining adhesive residue.

- Position the QM50 battery in its housing and correctly align the connector without forcing the flex cable.

- Use suitable fixing adhesive to secure the battery inside the device.

- Check device startup, battery percentage recognition and charging operation before final closure.

- Perform a full charge and check the battery level progression during a normal usage cycle.