Black PTZ lens 3 support for DJI Avata 2 premium quality

Black PTZ lens 3 support for DJI Avata 2 premium quality

Black PTZ lens 3 support for DJI Avata 2 in premium quality, designed to replace the damaged, marked, deformed or missing support part of the optical and stabilization assembly of the drone. This replacement part allows the correct fixing of the third lens area or corresponding PTZ support point to be restored, helping to maintain stable integration inside the visual module. It is a useful part for repairs caused by impacts, falls, disassembly, vibrations, transport or previous interventions on the camera. Its black finish preserves a consistent appearance with the DJI Avata 2 assembly and allows a precise, clean and workshop-oriented repair.

Key features

• Black PTZ lens 3 support for DJI Avata 2.

• Premium quality for professional repair.

• Designed to replace damaged, deformed, marked or missing supports.

• Suitable for repairs of the camera, lens or PTZ system assembly.

• Helps restore fixing and stability of the corresponding third optical area.

• Replacement part aimed at precise assembly and clean workshop finish.

Advantages and quality

Premium quality offers good fit, correct finish and suitable resistance for professional repair work. This support allows the PTZ lens 3 fixing area of the DJI Avata 2 to be restored when the damage is located in the support or fixing part, avoiding the replacement of larger assemblies if not necessary. Its installation helps keep the visual module correctly seated, reduce vibrations or misalignments and maintain a more stable structure after repair. To obtain a correct result, it is recommended to first check the anchor points, verify that there are no deformations in the housing or camera and perform a fit test before final closing. Available for immediate shipping from Spain.

Installation tips

1. Disconnect the drone battery before handling any component.
2. Check that the part corresponds to the PTZ lens 3 area of the DJI Avata 2.
3. Remove the damaged support without forcing clips, tabs or anchor points.
4. Clean the housing area before installing the new support.
5. Test fit the part cold to verify the fit.
6. Correctly align the support before fixing it or applying pressure.
7. Verify that there are no gaps, vibrations or interferences in the optical assembly.

Technical table