Set of 4 antennas for DJI Avata 2 premium quality

Set of 4 antennas for DJI Avata 2 premium quality

Set of 4 antennas for DJI Avata 2 in premium quality, designed to replace damaged, deteriorated, cut, marked or connection-faulty internal or external antennas within the drone transmission system. This set allows signal stability to be restored when the device has link loss, reduced range, intermittent disconnections, weak signal warnings or irregular behavior during flight. It is an especially useful replacement part after impacts, falls, disassembly, previous repairs or damage to the structure where the antennas are housed. Its format prepared for DJI Avata 2 makes workshop assembly easier and helps maintain more stable communication between the drone, controller and video system.

Key features

• Set composed of 4 antennas for DJI Avata 2.

• Premium quality for professional repair.

• Designed to restore signal transmission and reception stability.

• Recommended for link failures, loss of range or intermittent disconnections.

• Suitable for internal repairs after impacts, disassembly or structural damage.

• Helps restore more stable communication during drone use.

Advantages and quality

Premium quality offers good fit, stable contact and suitable integration inside the DJI Avata 2 antenna system. This set allows the affected antennas to be replaced when the fault is located in the reception or transmission assembly, avoiding intervention on larger modules if not necessary. For a correct repair, it is important to first check connectors, coaxial cables, anchor points and possible damage to the housing where the antennas are located. Its installation helps improve link stability, reduce signal cuts and restore more reliable operation of the flight and video system. Available for immediate shipping from Spain.

Installation tips

1. Disconnect the drone battery before handling any component.
2. Identify the position of each antenna before removing it.
3. Check coaxial connectors, internal guides and fixing points.
4. Install each antenna without bending, pinching or tensioning the cables.
5. Secure the connectors with aligned pressure and without forcing.
6. Perform a cold test before closing the housing.
7. Verify signal stability, control link and video transmission after assembly.

Technical table