Camera lens by Blackview Fort 1 premium quality

Camera Glass for Blackview FORT 1 Premium Quality

Rear camera glass for Blackview FORT 1 in premium quality, intended to replace the external protector of the photographic module when it has cracks, scratches or damage that may affect camera protection. This replacement part allows the rear assembly finish to be restored while keeping the lenses correctly protected against dirt and direct contact. Its format is designed to fit the corresponding Blackview FORT 1 camera module. Recommended for professional repair and compatibility checking before applying adhesive or carrying out final installation.

Specifications

External protective glass for the rear camera module of the Blackview FORT 1. Premium quality provides a precise finish and suitable geometry to facilitate installation, keeping the areas corresponding to cameras, flash and other elements of the photographic assembly clear. Before installation, it is important to completely remove the remains of the previous glass and adhesive, clean the surface and check the dry fit. Correct positioning prevents displacement over the lenses and allows the external protection of the module to be restored without replacing other components that are still in good condition.

Installation advice

Completely remove all remains of the damaged glass before fitting the replacement.

Carefully clean the surface and remove any adhesive residue.

Check the fit and position of all openings before applying adhesive.

Avoid touching the camera lenses directly during installation.

Use suitable adhesive and apply even pressure during sealing.

Check camera and flash operation before completing the repair.

Notice

Two different camera module designs have been observed associated with the Blackview FORT 1, with different external glass geometry. Some units or images show a more circular glass, while others feature a more polygonal design.

Before installation, it is essential to visually compare the shape, dimensions and position of the openings of the glass originally installed on the device with this replacement part. This glass should only be used when the geometry matches exactly. We always recommend carrying out a dry test before removing protective films or applying adhesive.

Technical table