Back cover or battery cover black by Blackview Fort 1

Black Rear Cover or Battery Cover for Blackview FORT 1

Rear cover or battery cover for Blackview FORT 1 in black, designed to replace the rear housing when it has impacts, cracks, deformation or wear. This replacement part allows the external protection of the device and the correct closure of the chassis to be restored, maintaining the corresponding access and geometry for the camera module. It is intended for professional repairs and it is recommended to check the fit beforehand, especially around the camera area, before applying adhesive or carrying out the final closure.

Specifications

Black rear cover compatible with Blackview FORT 1. It allows the factory-installed cover to be replaced when damaged without the need to replace other components that remain in good condition. Correct installation helps keep the inside of the device protected against dust and accidental contact.

The replacement part is prepared to facilitate stable assembly and restore the external finish of the device. Before installation, all adhesive residue must be completely removed from the housing, the contact surface cleaned and a dry test carried out to ensure that both the outline and the opening corresponding to the camera module exactly match the unit being repaired.

Available for immediate shipping from Spain.

Installation advice

Disconnect the battery before starting the repair.

Carefully remove the damaged cover without applying pressure to the battery or internal components.

Completely remove adhesive residue from the perimeter of the chassis.

Carry out a dry test before applying adhesive.

Pay particular attention to the shape and position of the opening corresponding to the camera module.

Use suitable adhesive for rear covers and apply even pressure during sealing.

Check the complete closure of the perimeter before completing the repair.

Notice

Two different designs have been observed associated with the Blackview FORT 1, with different external geometry around the camera module area. Some units or images show a more circular camera design, while others feature a more polygonal format.

Before installation, it is essential to visually compare the shape, dimensions and geometry of the camera area of the cover originally installed on the device with this replacement part. This cover should only be used when the shape and openings match exactly. We always recommend carrying out a dry test before removing protective films or applying adhesive.

Technical table