CBTL1701B0 Power management IC by para iPhone 17 17 Pro 17 Pro Max iPhone Air premium quality

CBTL1701B0 USB Type C Controller IC for Apple iPhone 17 A3520 iPhone Air A3517 iPhone 17 Pro A3523 iPhone 17 Pro Max A3526 Premium Quality

CBTL1701B0 USB Type C controller IC for Apple iPhone 17 A3520, iPhone Air A3517, iPhone 17 Pro A3523 and iPhone 17 Pro Max A3526 in Premium quality, corresponding to the variants sold in Spain and Europe. This NXP integrated circuit is intended for motherboard repairs related to the control and management of the USB Type C interface. It allows the component to be replaced when diagnosis confirms a fault in this section of the circuit. Professional spare part prepared for microsoldering work and advanced electronic repair.

Specifications

Component: USB Type C port controller IC

Reference: CBTL1701B0

IC manufacturer: NXP Semiconductors

Location: motherboard

Compatibilities: Apple iPhone 17 A3520, iPhone Air A3517, iPhone 17 Pro A3523, iPhone 17 Pro Max A3526

Quality: Premium

Premium quality provides a component suitable for professional motherboard repairs that require precision and stability after replacement. The CBTL1701B0 is involved in the management of the USB Type C interface, so before replacing it, it is recommended to check the charging connector, associated lines, power supply and possible short circuits. Its installation requires correct pad preparation and precise temperature control during the microsoldering process. After installation, charging functions, USB communication and the electrical behavior of the device must be verified. Designed to reduce repeat repairs through correct diagnosis and professional installation. Available for immediate shipping from Spain.

Installation Tips

Disconnect the battery before working on the motherboard.

Use ESD protection throughout the entire process.

Check the USB Type C connector and related lines beforehand.

Rule out short circuits and damage to associated components before replacing the integrated circuit.

Work with a microscope and a soldering station with precise temperature control.

Prepare and clean the pads correctly before installing the new IC.

Check charging, USB communication and electrical consumption before closing the device.

Warning

Replacing the CBTL1701B0 requires advanced microsoldering and electronic diagnosis knowledge. This component is technically identified as a USB Type C port controller and not as the device's main power controller. It is recommended to confirm the fault through measurements before proceeding with its replacement.

Technical Table