Charging port flex with microphone by Samsung Galaxy A16 4G A165F GH96-18451A Service Pack

Charging port flex + microphone for Samsung Galaxy A16 4G A165F (GH96-18451A) Service Pack

This technical module integrates the charging port flex and built-in microphone, restoring full connectivity on the Samsung Galaxy A16 4G A165F. It ensures proper power delivery, data transfer and audio capture through its USB-C connector, charging circuit and main microphone assembled according to the technical reference GH96-18451A, guaranteeing full compatibility and precise fitting on the motherboard. The Service Pack quality provides exact tolerances, stable contact points and reliable construction, ideal for professional repairs requiring durability, precision and electrical stability. It is suitable for recovering fast charging, data transfer and clear audio after wear, moisture exposure or failure of the original module.

Key features
• Complete module with USB-C connector and integrated microphone.
• Direct compatibility with Samsung Galaxy A16 4G A165F.
• Manufactured according to technical reference GH96-18451A.
• Pre-installed flex and connectors for fast, solder-free installation.
• Service Pack quality for professional repair.

Advantages and quality
Service Pack quality ensures precise assembly, stable charging performance, smooth data transfer and clear audio in calls and recordings. It prevents typical issues found in generic parts such as USB-C disconnections, microphone noise or intermittent charging. Its accurate tolerances simplify installation without forcing connectors, reduce repair time and minimize recurrence. It is a dependable replacement for workshops needing consistent, high-reliability components to restore the device’s original performance.

Installation advice

1. Power off the device and disconnect the battery.

2. Use ESD protection throughout the repair.

3. Remove cover, shields and screws carefully to avoid damaging flex cables or antennas.

4. Disconnect the battery first, then the old module.

5. Install the new module aligning the USB-C connector and microphone properly.

6. Test charging, data, audio and signal before sealing the chassis.

7. Close the device only after confirming full functionality.

8. Replace internal adhesives if needed.

Technical table