Charging port flex with microphone by Xiaomi Redmi 13 Xiaomi Poco M6 560002N19A00 Service Pack

Charging port flex + microphone for Xiaomi Redmi 13 / Xiaomi Poco M6 (560002N19A00) Service Pack

This technical module integrates the charging port flex and built-in microphone, restoring full connectivity on the Xiaomi Redmi 13 and Xiaomi Poco M6. It ensures proper power delivery, data transfer and audio capture through its USB-C connector, charging circuit and main microphone assembled according to the technical code 560002N19A00. The Service Pack quality provides exact tolerances, firm contacts and stable assembly, ideal for professional repairs requiring reliability and precise installation. It supports full pre-closure testing to confirm charging, data transfer and audio performance after failures caused by wear, moisture or component degradation.

Key features
• Complete module with USB-C connector and integrated microphone.
• Direct compatibility with Xiaomi Redmi 13 and Xiaomi Poco M6.
• Manufactured according to technical code 560002N19A00.
• Pre-installed flex and connectors for fast, solder-free assembly.
• Service Pack quality for professional repair.

Advantages and quality
Service Pack quality ensures accurate assembly, stable charging, smooth data transfer and clear audio in calls and recordings. It avoids typical issues found in generic parts such as USB-C disconnections, intermittent charging or microphone noise. Its precise tolerance simplifies installation without forcing connectors, reduces repair time and minimises recurrence. It is a dependable replacement for workshops seeking consistent, stable and high-reliability components to restore original device performance.

Installation advice

1. Power off the device and disconnect the battery.

2. Use ESD protection throughout the repair.

3. Remove cover, shields and screws carefully to avoid damaging flex cables or antennas.

4. Disconnect the battery first, then the old module.

5. Install the new module aligning the USB-C connector and microphone correctly.

6. Test charging, data, audio and signal before sealing the chassis.

7. Close only after confirming full functionality.

8. Replace internal adhesives if needed.

Technical table