Charging port flex with sim reader by Xiaomi 14T 5600010N12A00 Service Pack

Charging port flex + SIM reader for Xiaomi 14T (5600010N12A00) Service Pack

This technical module integrates the charging port flex and SIM reader, restoring full functionality on the Xiaomi 14T by ensuring correct power delivery, data transfer and SIM detection. It includes the USB-C connector, charging circuit and SIM reader in a single assembly built according to the technical code 5600010N12A00, guaranteeing full compatibility and precise fitting on the motherboard. The Service Pack quality provides exact tolerances, reinforced contacts and stable assembly for professional repairs requiring electrical reliability and secure mounting. Its design allows full functional testing before sealing the device, ideal after damage from wear, moisture or failure of the original module.

Key features
• Complete module with USB-C and integrated SIM reader.
• Direct compatibility with Xiaomi 14T following technical code 5600010N12A00.
• Pre-installed flex and connectors for fast, solder-free installation.
• Service Pack quality for professional repair.
• Precise fit preventing charging and SIM detection issues.

Advantages and quality
Service Pack quality ensures stable assembly, proper charging performance, smooth data transfer and reliable SIM reading. It avoids common issues found in generic parts such as SIM loss, USB-C disconnections or electrical instability. Its accurate tolerances simplify installation without forcing connectors, reduce repair time and minimise recurrence. It is a dependable option for repair shops needing consistent, high-reliability components to restore original device performance.

Installation advice

1. Power off the device and disconnect the battery.

2. Use ESD protection during the entire process.

3. Remove cover, shields and screws without damaging flex cables or antennas.

4. Disconnect the battery first, then the old module.

5. Install the new module aligning USB-C and SIM reader.

6. Test charging, data, SIM and signal before sealing.

7. Close the chassis only after confirming full functionality.

8. Replace internal adhesives if needed.

Technical table