Connection Board with Flash and Secondary Microphone for Doogee S200 Plus Premium Quality

Connection Board with Flash and Secondary Microphone for Doogee S200 Plus Premium Quality

Connection board with flash and secondary microphone for Doogee S200 Plus in premium quality, designed to restore several internal functions of the device from a single module. This replacement part allows the associated connection, flash operation and auxiliary audio capture to be recovered when the original part presents faults caused by moisture, impact, wear, internal dirt or previous handling. It is a solution indicated for repairs where the terminal presents lighting errors, noise cancellation problems, internal communication faults or intermittent response of the associated circuit.

Specifications

Connection board with flash and secondary microphone for Doogee S200 Plus.

Internal component intended for connection, auxiliary lighting and secondary audio capture.

Designed to recover electrical continuity, flash function and secondary microphone support.

Premium quality with precise fit for technical assembly.

Suitable for repairs due to damaged board, flash failure, poor audio or loss of internal connection.

Premium quality guarantees good electrical stability, firm contact and correct adaptation to the internal housing of the device. This board is aimed at workshops that need to recover several functions associated with the assembly without replacing other components when the fault is located in this module. Its installation helps solve common incidents such as flash without response, ambient audio problems, poor noise cancellation, false contacts or irregular circuit operation. It is recommended to previously check the connectors, the associated flex cable, the flash area and possible moisture residues before final assembly. Available for immediate shipping from Spain.

Installation tips

Disconnect the battery before starting the repair.

Use ESD protection throughout handling.

Remove the damaged board without forcing connectors or anchor points.

Clean the mounting area and check for possible moisture or dirt residues.

Correctly align the board before fixing it.

Test flash, audio recording and associated functions before closing the chassis.

Verify calls, video, noise reduction and connection stability after assembly.

Technical table