Dipslay by Unihertz Jelly Star with black touch screen with black frame version 02 premium quality

Screen for Unihertz Jelly Star + touch black with black frame version 02 premium quality

Complete screen with touch for Unihertz Jelly Star in black with black frame, designed to restore display and touch functionality when the original module is broken or shows image issues, lines, spots, or loss of touch sensitivity. This is a complete assembly integrating LCD panel and touch digitizer, allowing direct replacement with precise chassis fitting. Intended for professional repair and suitable for cold testing before final assembly.

Premium quality provides an experience equivalent to the original screen, with good sharpness, uniform brightness, and stable touch response. The pre-installed frame helps proper alignment during installation and reduces stress on the panel. An effective solution to extend the device lifespan and optimize repair times. Available for immediate dispatch from Spain.

Screen specifications

• Size: 3.0 inches
• Resolution: 480 × 854 pixels
• Panel type: IPS LCD
• Refresh rate: 60 Hz
• Touch: capacitive multi-touch
• Frame included: yes, black

Installation tips

Disconnect the battery before starting the repair.
Use ESD protection during handling.
Check the connector and pin count before installation.
Test display and touch functions before final assembly.
Ensure correct frame seating in the chassis.

Warning

This model has two different screen versions that are not compatible with each other.
Version 1 (V1 uses a 16-pin FPC connector) and Version 2 (V2 uses a 12-pin FPC connector).
This screen corresponds exclusively to Version 1 (16-pin). Before installation, it is essential to check the number of pins on the original screen connector.

Technical table