Display by Xiaomi Redmi Note 13 Pro 4G Xiaomi Poco M6 Pro 4G with black touch screen Oled quality

Black OLED display and touch screen for Xiaomi Redmi Note 13 Pro 4G 23117RA68G, Poco M6 Pro 4G 2312FPCA6G and Redmi Note 14S

OLED display and touch screen module for Xiaomi Redmi Note 13 Pro 4G 23117RA68G, Xiaomi Poco M6 Pro 4G 2312FPCA6G and Xiaomi Redmi Note 14S in black, designed to restore the image and touch control of the device. This replacement without frame integrates the display and digitizer into a single assembly prepared for professional installation. It offers a visible surface of 6.67 inches, a resolution of 2400 by 1080 pixels and compatibility with a refresh rate of up to 120 Hz.

Specifications

6.67 inch OLED display.

Resolution of 2400 by 1080 pixels.

Compatible refresh rate of up to 120 Hz.

Module composed of display and touch screen.

Black front color.

Flat format without frame.

Compatible with the fingerprint reader located under the display.

Compatible with Xiaomi Redmi Note 13 Pro 4G, Xiaomi Poco M6 Pro 4G and Xiaomi Redmi Note 14S. Shared compatibility between these models is documented for frameless AMOLED and OLED modules.

The OLED quality provides deep blacks, high contrast and more intense color reproduction than TFT alternatives. It maintains a stable touch response and allows the under-display fingerprint reader to remain functional when installation and calibration are carried out correctly. Its construction makes it easier to replace the display of the Redmi Note 13 Pro 4G or Poco M6 Pro 4G without replacing the central frame. It is a balanced solution for repairs that require a superior visual experience, good fluidity and precise integration inside the chassis. Available for immediate shipment from Spain.

Installation advice

Disconnect the battery and use ESD protection.

Test the display before removing protective films or applying adhesives.

Check the image, touch function, brightness and fingerprint reader before closing.

Completely clean the remaining adhesive from the frame.

Align the flex cable and connectors without bending them or applying pressure.

Use specific display adhesive and apply uniform pressure during sealing.

Perform fingerprint reader calibration after installation when necessary.

Notice

This compatible OLED display may show small differences in brightness, color tone, contrast or image size compared with the factory-installed display. The visible area may be slightly smaller and the black borders somewhat wider. The under-display fingerprint reader is functional, although it may require calibration after installation. Check the technical model and fully test the replacement before closing the device.

Technical table