Flash sensor flex by IIIF150 Action A5 Pro premium quality

Flash Sensor Flex Cable for IIIF150 Action A5 Pro Premium Quality

Flash sensor flex cable for IIIF150 Action A5 Pro in premium quality, designed to replace the flexible circuit responsible for connecting the sensor and flash lighting system to the main board. This replacement restores functions related to flash activation and electrical communication of the module when there are intermittent faults, no response or damaged tracks. Its shape, routing and connectors are adapted to the IIIF150 Action A5 Pro. Intended for professional installation, it must be compared with the removed part and tested before the final closing of the device.

Specifications

Flex cable for sensor and flash of the IIIF150 Action A5 Pro.

Component intended to transmit signal and power between the module and the main board.

Premium quality with connector, length and layout adapted to the device.

Camera, main board, lens, adhesives and other flex cables are not included unless expressly stated.

Premium quality provides stable electrical tracks, precise connectors and a suitable fit inside the device housing. This replacement enables replacement of only the affected flex cable without changing other modules that continue to operate correctly. It is suitable for repairing faults such as flash not activating, irregular operation, loss of communication with the sensor or damage caused by moisture, impacts or handling. Its design facilitates assembly and helps reduce repair times. Before final installation, it is advisable to check the cable routing, connector orientation and mounting points to prevent sharp bends or excessive pressure.

Available for immediate shipping from Spain.

Installation Advice

Disconnect the battery before handling the flex cable.

Use ESD protection throughout the repair.

Remove the damaged part without pulling the flexible cable.

Compare the connector, length and mounting points with the removed component.

Align the flex cable correctly and avoid sharp bends.

Check that there is no moisture, dirt or adhesive residue on the contacts.

Test the flash and sensor before closing the device.

Technical Table