Asus Zenfone 10 spare parts

    There are 21 products.

    Technical Characteristics of Asus Zenfone 10 Repuestos

    The Asus Zenfone 10 Repuestos refer to the replacement parts for the Asus Zenfone 10 smartphone. These are vital components required for the device to function properly.

    Key features include:

    • Screen: 6.4 inch, LCD capacitive touchscreen, 1080 x 2400 pixels resolution
    • Processor: Q...

    Technical Characteristics of Asus Zenfone 10 Repuestos

    The Asus Zenfone 10 Repuestos refer to the replacement parts for the Asus Zenfone 10 smartphone. These are vital components required for the device to function properly.

    Key features include:

    • Screen: 6.4 inch, LCD capacitive touchscreen, 1080 x 2400 pixels resolution
    • Processor: Qualcomm SDM855 Snapdragon 855 (7 nm)
    • Memory: 6 GB/8GB RAM
    • Storage: 128GB/256GB internal storage, expandable via MicroSD
    • Camera: 48 MP (+13 MP wide-angle) rear, 24MP front camera
    • Battery: 5000mAh non-removable Li-Po battery
    • Operating System: Android 9 with new ASUS ZenUI 6

    Instructions for Replacing Asus Zenfone 10 Repuestos

    Disassembly Process

    Ensure you turn off your phone before beginning this process. Remove the SIM card tray and unscrew the bottom screws using a T5 Torx bit.

    Screen Replacement

    To replace the screen, begin by heating the edge of the device with a heat gun on a moderate heat setting. Use a plastic spudger to carefully cut through the adhesive holding the screen. Once you've detached the screen, remove the old adhesive, apply a new layer, and place the new screen.

    Battery Replacement

    Remove the metal shield over the battery connector and using the plastic spudger, pry off the battery connector. Use an iSlack or similar tool to lift the battery out of the case, being careful not to puncture the battery. Replace with the new battery and reinstall the shield.

    Camera Replacement

    Unclip the small metal shield over the camera connector and disconnect the ribbon cable. Lift the camera module out and replace it with the new one. Reconnect the ribbon cable and clips over the top.

    Reassembly Process

    Take time to make sure all screws and connectors are back where they are meant to be. Then place the back cover on and press down firmly to ensure the adhesive sticks. Remember to replace the SIM card tray when you are done.

    Less
    More
    Showing 1 - 21 of 21 items