Cubot J20 spare parts

Cubot J20 Repuestos Technical Specifications

The Cubot J20 is an advanced feature smartphone with excellent components. Here are the main technical characteristics of Cubot J20 repuestos or spare parts:

• Screen: 6.5 inch, IPS, 720 x 1560 pixels
• Battery: 4200mAh, Non-removable Li-Po
• RAM: 3GB
• Storage: 64GB
• Camera: Rear 12MP+20MP+8MP, Front 13MP
• Processor: MediaTek, Quad-Core
• Operating System: Android 9.0

Instructions on How to Replace Cubot J20 Repuestos

Please ensure to follow these instructions very carefully for an effective replacement.

Tools Needed

• Small Phillips screwdriver
• Spudger
• Tweezers
• Opening tools

Device Disassembly

Follow the steps outlined below to disassemble the device:

1. Power off the device.
2. Remove the SIM/SD card tray.
3. Using the opening tool, start separating the rear case. This process may require some patience.
4. Remove the screws securing the middle frame and proceed to lift it up with a spudger.
5. Disconnect the Battery, Display and other connectors.

Replacing the Parts

Once the device is disassembled, follow these steps:

1. Identify the faulty component.
2. Use tweezers to carefully remove it.
3. Place the new component in the same place and connect it.

Device Reassembly

After replacing the parts, reassemble the device following the disassembly steps in reverse order.

NOTE: After reassembling, test the device to ensure the replaced component is working properly.