Cubot J3 2018 spare parts

Cubot J3 (2018) Technical Characteristics

The Cubot J3, released in 2018, is a durable and versatile smartphone that offers high quality components and a sleek design. Referred to as "repuestos", these components can be easily replaced following the correct procedure.

Key Features:

• Display: 5.0 inches, 480 x 960 pixels, 18:9 ratio (~215 ppi density)
• OS: Android Go Edition
• Processor: MediaTek MT6580 Quad-core 1.3 GHz
• RAM: 1GB
• Internal Storage: 16GB, expandable up to 32GB with microSD
• Camera: Single 5MP rear camera and 2MP front camera
• Battery: Removable Li-Ion 2000 mAh battery

Instructions to Replace Cubot J3 2018 Repuestos

Please follow these instructions carefully to replace specific components (repuestos) on the Cubot J3 (2018). Remember to switch off and disconnect the device from any power source before starting the process.

Replacing Screen

• Remove the back cover and battery to prevent any electrical damage.
• Use a suction cup to gently lift the screen from the bottom up.
• Disconnect the display connector from the motherboard.
• Install a new display screen and reconnect the connector. Gently test the fit before fully pressing the screen into place.

Replacing Battery

• Remove the back cover of the phone gently.
• Remove the old battery by carefully lifting from the bottom with a spudger.
• Install the new battery by sliding it into the phone and ensuring it's secure.

Replacing Camera

• Remove back cover, battery, and unscrew the protective cover over the motherboard.
• Disconnect the camera connector, lift out the camera module.
• Place the new camera module in, connect its cable.

Rescrew all unscrewed parts, and fit the back cover to the phone after every replacement.