Cubot J3 Pro spare parts

Technical Characteristics of Cubot J3 Pro Repuestos

Before we discuss the replacement process, it's important to understand the technical characteristics of the Cubot J3 Pro repuestos.

• Screen: Ultra-Precise 5-Inch Touch Display (480 X 960 Pixels).
• Battery: High capacity 2800mAh, replaceable Li-ion battery.
• Camera: Rear camera- 8.0MP, Front camera- 5.0MP.
• Ram: 1GB
• ROM: 16GB, expandable up to 64 GB using MicroSD card.

Instructions on replacing Cubot J3 Pro Repuestos

Follow the detailed steps below to replace your Cubot J3 Pro repuestos:

1. Turn Off the Device

Start by powering off your Cubot J3 Pro to prevent any possible electric shocks or damage to the phone's components.

2. Remove The Back Cover

Use a plastic tool to gently pry open the back cover starting from the bottom edge of the device. Continue the process along both sides. Make sure you do this carefully to avoid any damage.

3. Disconnect and Remove The Battery

Unclip the battery connector from the motherboard. Now, carefully lift the battery using a plastic tool and set it aside.

4. Remove The Display Assembly

Unscrew the screws securing the display assembly. Gently lift the display assembly away from the phone.

5. Install New Repuestos

Install your new Cubot J3 Pro repuestos in the reverse order of how you removed them. Make sure each part fits perfectly.

6. Confirm Functionality

Once you have replaced the repuestos, turn on your device to confirm everything is functioning as expected.

Note: Always remember to cross-check each replacement part you install to ensure they are correctly installed and avoid causing additional damage to your phone.