Cubot King Kong Power 9 Pro spare parts

Technical Characteristics of Cubot King Kong Power 9 Pro

The Cubot King Kong Power 9 Pro is an impressive robust smartphone designed for extensive use in any environment. Below are its essential technical specifications:

• Display: 6.3" HD+ (1600 x 720 pixels) display protected with Corning Gorilla Glass
• Battery: 6000mAh Polymer Lithium Battery
• Camera: Quad Camera Rear (48MP + 5MP + 0.3MP + 0.3MP) and 16MP Front Facing Camera
• Processor: MediaTek MT6762D Helio P22 (12 nm) Octa-Core Processor
• RAM and Storage: 4GB RAM + 64GB Internal Storage, expandable up to 128GB with TF card
• Operating System: Android 11
• Connectivity: 4G VoLTE, Wi-Fi 802.11, Bluetooth 5.0
• Durability Ratings: IP68 Waterproof, Dustproof, Drop Proof

Instructions to Replace Cubot King Kong Power 9 Pro repuesto

Tools Needed

• Screwdriver
• Tweezers
• Opening Tools (Plastic Pry Tool)
• Hot Air Gun/Blower

Step-by-step Guide

Follow this detailed guide on the replacement process. Always take precautions to avoid any accidental damage during the repair.

• Step 1: Switch off the phone to prevent any electrical damage during the repair.
• Step 2: With the help of the hot air gun, heat the edges of the back cover to soften the adhesive.
• Step 3: Use the plastic pry tool to carefully lift the back cover starting from the heated edges. Take care not to damage any internal parts.
• Step 4: Remove the visible screws using the screwdriver. Keep each set of screws separate to ensure they go back to their correct placing.
• Step 5: Lift the protective plate using the tweezers.
• Step 6: Disconnect the various connectors, including the battery connector.
• Step 7: Take out the defective part carefully, ensuring you do not damage any surrounding components.
• Step 8: Replace the part with the new Cubot King Kong Power 9 Pro repuesto. Ensure it fits correctly into place.
• Step 9: Reconnect all the connectors and replace the protective panel, securing it with the previously removed screws.
• Step 10: Finally, place back the cover, reheat it slightly if necessary, and push down gently for the adhesive to secure. Power on your phone to make sure the new part is working properly.

Please note that this process requires technical expertise, and you should only attempt it if you are confident in your abilities. Consider seeking professional help if needed.