iPhone 6 repair parts

Technical Specifications of Repuestos iPhone 6

The following are the detailed technical specifications of the Repuestos iPhone 6:

• Display: 4.7 inch (diagonal) LED-backlit widescreen, 1334-by-750-pixel resolution at 326 ppi
• Processor: A8 chip with 64-bit architecture
• Storage: Available in 16GB, 64GB, and 128GB
• Camera: 8-megapixel rear camera, 1.2-megapixel front camera
• Battery: Built-in rechargeable lithium-ion battery, up to 14 hours talk time, up to 10 days standby time.

How To Replace Repuestos iPhone 6

Preparation

Before starting the repair, make sure to turn off the iPhone. You will also need the following items:

• P2 Pentalobe Screwdriver
• Phillips #000 Screwdriver
• Spudger
• Suction cup

Step 1: Remove the Screws

Remove the two 3.6 mm Pentalobe screws next to the lightning connector.

Step 2: Opening the Phone

Use a suction cup and a plastic opening tool to gently pry the front panel assembly from the rear case.

Step 3: Disconnecting the Battery

First remove the two 1.6mm Phillips#000 screws securing the battery connector bracket, then remove the bracket, and finally use a plastic opening tool to gently disconnect the battery connector.

Step 4: Removing the Front Panel Assembly

Remove the five Phillips#000 screws securing the front panel assembly cable bracket. After removing the bracket, you can disconnect the front camera, sensor cable, and the home button cable from their respective sockets on the logic board.

Step 5: Transferring the Home Button

Remove the two 1.9mm Phillips#000 screws securing the home button bracket, and remove it. After, carefully disconnect and remove the home button assembly.

Step 6: Replacement

At this point, you can replace the faulty parts or install a new screen. Remember to transfer the home button assembly to the new part, if needed.

Reassembling

Ensure all components are secure and in their place. Repeat the steps in reverse to assemble the phone. Remember that every screw must go back exactly where it came from. Failing to do so might cause damage to the logic board.