Nokia 3.4 spare parts

Nokia 3.4 Repuestos Technical Characteristics

The Nokia 3.4 offers a notable upgrade from its predecessor, presenting several key components available for repair or replacement. Below are some critical technical features:

• Display: 6.39 inches, 720 x 1560 pixels, IPS LCD capacitive touchscreen, 16M colors
• Processor: Qualcomm SM4250 Snapdragon 460 (11 nm)
• Memory: RAM- 3GB or 4GB, Internal Storage- 32GB or 64GB, expandable up to 512GB via MicroSDXC
• Battery: Li-Po 4000 mAh, Non-Removable
• Rear Camera: 13 MP Main camera, 5 MP Ultra-wide camera, 2 MP Depth sensor
• Front Camera: 8 MP Selfie camera

Instructions for Replacing Nokia 3.4 Repuestos

Please be aware that replacing parts of a mobile phone should be undertaken by a professional or under expert guidance. Misapplication might result in damaging the phone further.

Tools you will need:

• ESD-safe tweezers
• Philips #000 Screwdriver
• Opening Picks
• Nylon Spudger
• iFixit opening tool or suction handle

Procedure:

Follow the steps below to replace parts of the Nokia 3.4:

1. Switch off the Nokia 3.4: Before starting, always ensure that the phone is powered off to prevent any electrical mishaps.
2. Remove the SIM tray: Use the SIM tray ejector, push into the small hole on the left top side, pull out the tray & keep it aside.
3. Opening the rear cover: Use the iFixit opening tools to gently pry loose the adhesive holding the back cover to the phone.
4. Disconnecting the battery: Utilize your ESD-safe tweezers or the nylon spudger to disconnect the battery from the motherboard.
5. Unscrew the damaged part: Use your Philips #000 Screwdriver to remove the screws holding the damaged part. Make sure to keep a record of the order and location of each screw for reassembly.
6. Replacing the part: With thedamage part removed, you can now install the new component. Make sure the new part is of the correct spec and is compatible with the Nokia 3.4.
7. Reassembly: Once the part is successfully replaced, follow the steps in reverse to reassemble the phone. Be sure to check for full functionality before committing to sealing the phone shut.

Note: Ensure to reconnect all the disconnected cables and snap all clips back into place during reassembly.