Oppo Reno 4 SE spare parts

Technical Characteristics of Oppo Reno 4 SE Repuestos

The Oppo Reno 4 SE is a sophisticated device with intricate parts. When replacing components, it's crucial to understand the technical specifications of each repuesto (replacement part).

Common Repuestos for Oppo Reno 4 SE

• Display Assembly

The display is a 6.43-inch AMOLED screen with a resolution of 1080x2400 pixels. It includes the digitizer and the front glass.

• Battery

The battery is a non-removable Li-Po 4300 mAh battery that supports 65W SuperVOOC 2.0 fast charging.

• Rear Camera Module

The primary camera module includes a 48 MP main sensor, 8 MP ultrawide sensor, and 2 MP macro sensor.

• Front Camera Module

The front camera is a single 32 MP sensor.

• Charging Port

The charging port is a USB Type-C interface that requires specific tools for replacement.

Instructions for Replacing Oppo Reno 4 SE Repuestos

Replacing components on the Oppo Reno 4 SE requires technical skills and proper tools. The following are detailed instructions to replace some of the most common parts.

Replacing the Display Assembly

• Power off the device and remove the SIM card tray.
• Apply a heat source to soften the adhesive around the edges of the back cover.
• Use a suction cup and a plastic opening tool to gently pry open the back cover.
• Unscrew the screws securing the mid-frame and remove it to expose internal components.
• Disconnect the battery connector to avoid short circuits.
• Locate and detach the display connector from the motherboard.
• Apply a heat source to the front of the screen to soften the adhesive securing the display assembly.
• Gently use a plastic opening tool to remove the old display assembly.
• Clean any remaining adhesive on the frame and apply new adhesive strips.
• Connect the new display assembly and reassemble the device in the reverse order.

Replacing the Battery

• Power off the device and remove the SIM card tray.
• Apply a heat source to soften the adhesive around the edges of the back cover.
• Use a suction cup and plastic opening tool to gently pry open the back cover.
• Unscrew the screws securing the mid-frame and remove it to expose the battery.
• Disconnect the battery connector from the motherboard.
• Use a plastic card to carefully lift and remove the battery from the adhesive.
• Install the new battery by connecting it to the motherboard and securing it in place.
• Reassemble the device by following the steps in reverse order.

Replacing the Rear Camera Module

• Power off the device and remove the SIM card tray.
• Apply a heat source to soften the adhesive around the edges of the back cover.
• Use a suction cup and a plastic opening tool to gently pry open the back cover.
• Unscrew the screws securing the mid-frame and remove it to expose the camera module.
• Disconnect the camera connectors from the motherboard.
• Carefully remove the rear camera module from the device.
• Install the new camera module by connecting it to the motherboard.
• Secure the mid-frame and back cover in place by following the steps in reverse order.

Replacing the Charging Port

• Power off the device and remove the SIM card tray.
• Apply a heat source to soften the adhesive around the edges of the back cover.
• Use a suction cup and plastic opening tool to gently pry open the back cover.
• Unscrew the screws securing the mid-frame and remove it.
• Disconnect the battery and the charging port flex cable from the motherboard.
• Unscrew and remove the charging port assembly.
• Install the new charging port assembly and reconnect the flex cable to the motherboard.
• Reassemble the device by securing the mid-frame and back cover in place.