Oppo Reno5 5G PEGM00 PEGT00 spare parts

Technical Characteristics of Oppo Reno5 5G PEGM00 PEGT00 Repuestos

Specifications

• Model Number: PEGM00/PEGT00
• Display: 6.43 inches, 1080 x 2400 pixels
• Processor: Qualcomm Snapdragon 765G
• RAM: 8GB
• Internal Storage: 128GB
• Operating System: Android 11, ColorOS 11.1
• Rear Camera: 64 MP + 8 MP + 2 MP + 2 MP
• Front Camera: 32 MP
• Battery: 4300 mAh, fast charging 65W
• Connectivity: 5G, Wi-Fi 802.11 a/b/g/n/ac, Bluetooth 5.1

Common Replacement Parts

• LCD and Touch Screen Digitizer Assembly
• Battery
• Charging Port Flex Cable
• Rear Camera Module
• Front Camera
• Ear Speaker
• Loudspeaker

Instructions to Replace Oppo Reno5 5G PEGM00 PEGT00 Repuestos

Tools Required

• Phillips #00 Screwdriver
• Plastic Pry Tools
• Suction Cup
• Tweezers
• Heat Gun or Hair Dryer
• SIM Ejector Pin
• Adhesive Tape

Steps for Replacing the LCD and Touch Screen Digitizer Assembly

Step 1: Power off the phone and remove the SIM card tray using the SIM ejector pin.

Step 2: Use a heat gun or hair dryer to slightly heat the edges of the back cover to soften the adhesive.

Step 3: Place a suction cup on the back cover and gently lift to create a gap. Insert a plastic pry tool into the gap and carefully work around the edges to release the back cover.

Step 4: Once the back cover is removed, use a Phillips #00 screwdriver to remove all screws securing the internal frame and components.

Step 5: Disconnect the battery connector using the plastic pry tool to avoid any electrical damage.

Step 6: Disconnect the display connector and any other flex cables attached to the motherboard.

Step 7: Use a heat gun or hair dryer to heat the front screen edges, then use the suction cup and a plastic pry tool to lift and separate the screen from the frame.

Step 8: Remove the old screen and replace it with the new LCD and touch screen digitizer assembly. Ensure all connectors are properly aligned and attached.

Step 9: Reconnect the display, battery, and other flex cables to the motherboard.

Step 10: Reassemble the internal frame and components, securing all screws back into place.

Step 11: Reapply adhesive to the back cover and press it firmly back into place. Use the heat gun or hair dryer if necessary to help the adhesive set.

Step 12: Power on the device to ensure the new screen is functioning correctly.

Step 13: Reinsert the SIM card tray.

Congratulations! You have successfully replaced the LCD and touch screen digitizer assembly of your Oppo Reno5 5G PEGM00 PEGT00.