Oukitel C4 spare parts

Oukitel C4 Spare Parts Technical Characteristics

The Oukitel C4 is equipped with a variety of components that may require replacement over time. Below are the technical characteristics of its primary spare parts:

Display

• Size: 5.0 inches
• Resolution: 720 x 1280 pixels
• Type: IPS LCD capacitive touchscreen

Battery

• Capacity: 2000 mAh
• Type: Li-Ion
• Removable: Yes

Camera

• Rear Camera: 8 MP
• Front Camera: 5 MP
• Flash: LED

Motherboard

• Processor: MediaTek MT6737
• RAM: 1 GB
• Internal Storage: 8 GB
• MicroSD Support: Up to 32 GB

Instructions for Replacing Oukitel C4 Spare Parts

Follow these detailed steps to replace the spare parts of your Oukitel C4:

Preparing for Replacement

• Ensure the device is powered off.
• Gather necessary tools: small Phillips screwdriver, plastic prying tool, tweezers.
• Work on a clean, flat surface for stability and to avoid losing small parts.

Replacing the Battery

• Remove the back cover using the plastic prying tool.
• Gently lift and remove the old battery.
• Insert the new battery in the same orientation.
• Replace the back cover and ensure it clicks into place securely.

Replacing the Display

• Remove the back cover and battery as described above.
• Locate and unscrew all visible screws using the Phillips screwdriver.
• Carefully disconnect the ribbon cables connected to the display.
• Use the plastic prying tool to gently lift and remove the broken display.
• Attach the new display by connecting the ribbon cables.
• Reattach all screws and replace the battery and back cover.

Replacing the Rear Camera

• Remove the back cover and battery as described above.
• Locate the rear camera module on the motherboard.
• Unscrew any securing screws and disconnect the camera connector.
• Remove the old camera and insert the new one in the same position.
• Reconnect the camera connector and secure it with the screws.
• Replace the battery and back cover.

Ensure all components are securely connected and the handset is reassembled properly before powering it on to test the new parts.