Oukitel touch screen

Technical Characteristics of Pantalla Táctil Oukitel

Model: Oukitel X5

Type: Capacitive touchscreen

Size: 5.5 inches

Resolution: 1920 x 1080 pixels

Pixel Density: ~401 ppi pixel density

Technology: IPS LCD

Protection: Corning Gorilla Glass 3

Instructions for Replacing Pantalla Táctil Oukitel

Tools Needed

• Phillips Screwdriver
• Plastic Pry Tools
• Tweezers
• Spudger
• Heating Pad or Hairdryer
• Replacement Adhesive Strips
• Replacement Screen

Step-by-Step Instructions

Step 1: Power Off the Device

Ensure the phone is completely powered off to avoid any electrical damage.

Step 2: Remove the Back Cover

Use a plastic pry tool to carefully remove the back cover. Start from one corner and work your way around the edges.

Step 3: Detach the Battery Connector

Using the Phillips screwdriver, remove the screws securing the battery connector. Carefully lift the connector with a spudger and detach it to prevent any electrical current from running through the device.

Step 4: Remove the Midframe

Locate and unscrew the screws holding the midframe. Use a plastic pry tool to carefully separate the midframe from the phone. Set the screws aside in a safe place.

Step 5: Disconnect the Display Connector

Unscrew any screws securing the display connector and gently disconnect it using the spudger or tweezers.

Step 6: Heat the Edges of the Screen

Use a heating pad or hairdryer to gently warm the edges of the screen. This helps in softening the adhesive and makes it easier to remove the current screen.

Step 7: Pry Off the Old Screen

Utilize the plastic pry tool to carefully lift and remove the old screen from the phone chassis. Start at a corner and gradually work around the device to fully remove it.

Step 8: Clean the Frame

Remove any remaining adhesive from the frame using a light solvent if necessary. Ensure the frame is clean and free from any debris.

Step 9: Attach New Screen Adhesive

Apply new adhesive strips to the frame. Align the adhesive carefully to ensure complete contact once the new screen is installed.

Step 10: Connect the New Screen

Once the adhesive is in place, connect the new screen’s flex cable to the display connector. Secure it with the screws if necessary.

Step 11: Reassemble the Phone

Start by reattaching the midframe, securing it with screws. Connect the battery connector back and secure it. Finally, snap the back cover into place.

Step 12: Test the New Screen

Power on the device and test the new touchscreen to ensure it is functioning correctly. Check for responsiveness and display clarity.

Conclusion

You have successfully replaced the Pantalla Táctil Oukitel. If you encounter any issues, ensure all connections are secure and adhesive is properly applied.