Oukitel WP18 spare parts

Oukitel WP18 Technical Characteristics and Replacement Instructions

Technical Characteristics

The Oukitel WP18 is a rugged smartphone designed for durability and performance. Below are the key technical characteristics of Oukitel WP18 repuestos (replacement parts):

• Battery: 12500mAh Lithium-ion, providing extended battery life.
• Screen: 5.93-inch HD+ display with 720x1440 resolution.
• Camera: Dual rear camera setup with 13MP primary sensor and 8MP secondary sensor.
• Processor: MediaTek Helio A22 Quad-Core 2.0GHz.
• RAM: 4GB LPDDR4X.
• Storage: 64GB internal storage, expandable via microSD.
• Operating System: Android 11.

Instructions for Replacing Oukitel WP18 Repuestos

Tools Required

• Screwdriver set (including Phillips and Torx)
• Plastic prying tools
• Metal spudger
• Suction cup
• Anti-static wrist strap

Steps to Replace the Battery

• Power off the device and remove any external SIM or SD cards.
• Use the screwdriver to remove all screws from the back panel.
• Carefully insert a plastic prying tool between the back cover and the phone frame. Gently pry open the back cover.
• Disconnect the old battery by carefully disconnecting the battery connector from the motherboard.
• Remove the old battery from its adhesive using a plastic prying tool.
• Place the new battery in the same orientation as the old battery and connect it to the motherboard.
• Reattach the back cover and screw it into place.
• Power on the device to test the new battery installation.

Steps to Replace the Screen

• Power off the device completely and remove any external SIM or SD cards.
• Remove all screws securing the back panel using the screwdriver set.
• Carefully use a suction cup to lift the screen slightly and insert a plastic prying tool to detach the screen from the housing.
• Disconnect the display connector from the motherboard by using a metal spudger to gently lift the connector.
• Remove the damaged screen and replace it with a new one, making sure to connect the display connector securely to the motherboard.
• Reattach the screen to the housing, making sure it is properly aligned.
• Secure the back panel with screws and power on the device to test the new screen.