Umidigi A11 spare parts

Technical Characteristics of Umidigi A11 Repuestos

The Umidigi A11 phone is a high-performance item demanding corresponding high-quality repuestos. Some of these essential components include the screen, battery, charging port, and the camera lens.

Screen

The device features a 6.53" HD+ display with screen resolution of 720x1600 pixels, offering an immersive viewing experience.

Battery

The Umidigi A11 has a robust Li-Po 5150 mAh battery, ensuring extended usage between charges.

Charging Port

This device uses a USB Type-C charging port, offering fast and streamlined charging capabilities.

Camera Lens

Boasting a high-quality camera, the main lens is a 16MP unit, with secondary wide-angle and macro lenses included. An 8MP front camera ensures clear and crisp selfies.

Instructions for Replacing Umidigi A11 Repuestos

Replacing the components of your Umidigi A11 should be done with extreme care.

Tools Needed

• Eject Pin
• Screwdriver Set
• Plastic Pry Tools
• Tweezers

Replacing the Screen

Turn off your device and remove your SIM card tray with the eject pin. Heat the edges of your screen with a blow dryer or heat gun to soften the adhesive. Use the plastic pry tool to slowly lift the screen, starting from the bottom since the top part houses the display cable connector. Disconnect the connector and replace the screen with the new one.

Replacing the Battery

After opening the device following the procedure described above, remove any screws securing the battery connector to the motherboard. Disconnect the battery connector and carefully remove the battery. Insert the new battery, ensuring the connector fits snugly into the motherboard.

Replacing the Charging Port

After opening the device and removing the battery, locate the charging port, often towards the bottom of the device. Remove any screws and disconnect the charging port ribbon from the motherboard. Replace with the new charging port, secure it with screws and reconnect the ribbon.

Replacing the Camera Lens

The procedure is the same as for the battery, but locate the camera module instead. Be careful to place the new camera in the exact position of the previous one to ensure good alignment.