Wiko other repair parts

    There are 6 products.

    Wiko Otros Repuestos Technical Specifications

    The Wiko Otros Repuestos constitute a broad category of components integral to the satisfactory functioning of a Wiko mobile device. Here, we are going to discuss about some of the key components and their respective technical specifications:

    Battery

    • Capacity: 3000mAh (may vary with models)
    • Usa...

    Wiko Otros Repuestos Technical Specifications

    The Wiko Otros Repuestos constitute a broad category of components integral to the satisfactory functioning of a Wiko mobile device. Here, we are going to discuss about some of the key components and their respective technical specifications:

    Battery

    • Capacity: 3000mAh (may vary with models)
    • Usage Time: Up to 18 hours on 3G
    • Standby time: Up to 280 hours

    Display Screen

    • Resolution: 720 x 1280 pixels
    • Screen size: 5” (depends on model)

    Camera

    • Rear camera: 8MP to 12MP (varies by models)
    • Front camera: 5MP to 8MP (varies by models)

    Replacement Guide for Wiko Otros Repuestos

    Please note that improper handling may lead to potential damages. Following these steps will guide you through the generic process of replacing parts on a Wiko device:

    Preparation

    • Ensure that the device is powered off.
    • Remove the back cover from the device.
    • Remove the battery, if it isn’t inbuilt.

    Replacing Components

    Each component requires specific procedures. Here are some guidelines:

    Display

    • Locate the screws around the corners of the front display.
    • Using a screwdriver, gently remove these screws.
    • Lift the screen carefully and disconnect any cables linking it to the motherboard.
    • Replace the screen with a new one, reconnect the cables and reassemble.

    Battery

    • If the battery is inbuilt, locate the connector on the motherboard and disconnect it.
    • Replace it with the new battery and connect it back.

    Camera

    • Locate the camera module and gentle disconnect any cables linking it to the motherboard.
    • Replace it with the new camera module, reconnect the cables.
    • Reassemble everything back together into their respective slots.

    Note: Always ensure that the device is off during this exercise to avoid electrical short circuits and damages. If in doubt, please seek professional help.

    Less
    More
    Showing 1 - 6 of 6 items