Wiko View 2 spare parts

Wiko View 2 Repuestos Technical Characteristics

The Wiko View 2 Repuestos is a smartphone that features a range of parts, each of which offers unique technological characteristics.

• Display: The device includes a 6.0 inches, 92.9 cm2 (~77.9% screen-to-body ratio) IPS LCS display with a resolution of 720 x 1528 pixels.
• Processor: Powering the smartphone is a Quad-core 1.4 GHz Cortex-A53., Qualcomm MSM8937 Snapdragon 430 (28 nm).
• RAM and Storage: Internally, the smartphone contains 3GB RAM and offers 32GB of storage, expandable up to 256GB via a microSD slot.
• Camera: The device features a 13MP rear camera and a 16 MP, f/2.0, 27mm (wide), 1/3.06", 1.0µm, AF front camera.
• Battery: A non-removable Li-Po 3000 mAh battery is also present in the device, providing ample power capacity.
• Operating System: It runs on Android 8.0 (Oreo), offering a flexible, user-friendly interface.

Instructions on How to Replace Wiko View 2 Repuestos

Replacing parts on your Wiko View 2 Repuestos requires careful attention and the use of specific tools. Always ensure that the power is switched off before beginning any repair process. The instructions below offer a detailed guide:

• Step 1: Remove the Back Cover: Use a prying tool to gently detach the back cover from the device, applying even pressure around all corners. Be gradual to avoid any damage.
• Step 2: Remove the Battery: Once the back cover is removed, you should see a series of screws which secure the battery; remove these with a suitable screwdriver. After the screws have been removed, carefully lift out the battery.
• Step 3: Replace the Damaged Repuestos: With the battery removed, you can now access the motherboard where the RAM, processor, and other critical parts are located. If you are replacing the screen, disconnect it from the motherboard. Follow this process in reverse when installing the new part.
• Step 4: Reassemble the Device: Once the damaged part has been successfully replaced, reassemble the device by putting the battery back into position and replacing the screws. Finally, snap the back cover back onto the device.

Note: While carrying out these steps, ensure that you are working in a clear, well-lit space and avoid directly touching any of the device's internal components.