ZTE Nubia Z17 Mini S NX589J repuestos

    There is 1 product.

    Technical Specifications of ZTE Nubia Z17 Mini S NX589J Repuestos

    The ZTE Nubia Z17 Mini S NX589J Repuestos is a high-end smartphone equipped with superior hardware and software features. The internal assembly of this device features the following technical characteristics:

    • Display: 5.2” Full HD 1920x1080 resolution
    • Processor: Octa-Core Qualco...

    Technical Specifications of ZTE Nubia Z17 Mini S NX589J Repuestos

    The ZTE Nubia Z17 Mini S NX589J Repuestos is a high-end smartphone equipped with superior hardware and software features. The internal assembly of this device features the following technical characteristics:

    • Display: 5.2” Full HD 1920x1080 resolution
    • Processor: Octa-Core Qualcomm Snapdragon 653 (MSM8976 Pro)
    • Memory: 6GB RAM, 64GB internal storage
    • Battery: Non-removable Li-Ion 3200 mAh
    • Operating System: Android 7.1 Nougat with nubia UI5.0
    • Camera: Dual rear camera 13MP + 13MP, 16MP front camera

    Instructions for Replacing ZTE Nubia Z17 Mini S NX589J Repuestos

    Before you begin, make sure to turn off the phone and disconnect it from any power source. Here are the detailed steps for the replacement:

    Display and Touch Screen Replacement

    • Remove the SIM tray using the SIM card removal tool.
    • Use a heat gun to loosen the adhesive that attaches the screen to the phone
    • Delicately remove the damaged display screen and touch panel using a thin, flat tool, like a plastic opening tool or a spudger.
    • Install the new display and touch panel, then reconnect the display and touch cables.
    • Re-apply the adhesive to secure the display to the phone, making sure it is properly aligned.

    Battery Replacement

    • Use the spudger to gently pry up the battery connector.
    • Remove the old battery from the device.
    • Insert the new battery, ensuring it aligns with the battery connector and fits comfortably in its place.
    • Reconnect the battery connector to the logic board.

    Camera and Lens Replacement

    • Remove the device's back cover.
    • Use a spudger to carefully lift the camera connectors off the board.
    • Remove the old camera and replace it with the new one.
    • Reattach the connectors, ensuring they are secure and properly connected.
    • Reinstall the back cover.

    Note: The replacement process may vary depending on the specific part to be replaced. Always ensure to handle electronic parts with care to avoid damaging other components.

    Less
    More
    Showing 1 - 1 of 1 item